Installation guide

2. Move the door strike

Using a TORX T25®screwdriver, remove the 2 screws

securing the door strike to the door frame of the dryer.

Remove the 4 screws above and below the door strike and

set aside for later use. Rotate the strike 180° and attach to

the opposite side of dryer door frame, as shown.

3. Remove inner door from outer door

Release tab 1_

Release tab

Position the door with the inside of the door facing up. Using

a Phillips screwdriver, remove the 13 screws securing the

inner door to the outer door. Lift off the inner door and set

aside.

NOTE: There is a small release tab on each side of the door.

If the inner and outer door do not separate easily, slide a

credit card, putty knife, or similar flat object between the inner

and outer doors at the locations shown to release the tab.

f4. Remove hinge and latch

from inner door

Latch ;; :

Hinge

Using a TORX T25®screwdriver, remove the 3 TORX ®screws

securing the latch plate and the 5 screws holding the hinge

assembly in place.

5, Reinstall hinge and latch on

opposite sides

Latch ;

Latch

Using a TORX T25®screwdriver, reinstall the latch plate and

hinge assembly on the opposite sides from which they were

removed.