Installation guide

CONNECT VENT LEVEL DRYER
(z % (—
1. Connect vent to exhaust outlet 1. Level Dryer
Place
level here
Place
level here
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is
clean. Dryer vent must fit over dryer exhaust outlet and inside
exhaust hood. Check that vent is secured to exhaust hood
with a 4" (102 mm) clamp. 1
Check levelness of dryer from side to side. Repeat from
(
= 2
2.
Move
dryer
to
final
location
front
to
back,
NOTE: The dryer must be level for the moisture sensing
system to operate correctly.
Not Level LEVEL Not Level
fr
2. Adjust leveling legs
Move dryer to final location. Avoid crushing or kinking vent.
After dryer is in place, remove cardboard from under dryer.
if dryer is not level, prop up using a wood block, use wrench
to adjust legs by backing out the foot as needed, then checking
again for levelness. Once legs are level, make sure ail four legs
are snug against the floor.
14