Installation guide

INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed for all installations:
Flat-blade screwdriver Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Level Vent clamps
q.
Utility knife Caulking gun and compound
(for installing new exhaust vent)
mn 7
eke
SS
Tin snips (new vent 1/4"( 6 mm) nut driver
installations) (recommended)
8
i
Tape measure Pliers
Tools needed for gas installations:
—U fy)
8" (203 mm) or 10" 8" (203 mm) or 10"
(254 mm) pipe wrench (254 mm) adjustable wrench
(for gas connections)
Pipe-joint compound
resistant to LP gas
Parts supplied (all models):
Leveling legs (4)
Parts supplied (steam models):
“Y” connector 2' (0.6 m) inlet hose
5' (1.5 m) Inlet Hose Rubber washer
Remove parts package from dryer drum. Check that all parts
are included.
Parts needed: (Not supplied with dryer)
Check local codes. Check existing electrical supply and venting.
See “Electrical Requirements” and “Venting Requirements”
before purchasing parts.
Mobile home installations require metal exhaust system hardware
available for purchase from the dealer from whom you purchased
your dryer. For further information, please refer to the “Assistance
or Service” section in your “Use and Care Guide”.