Installation guide

INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools needed for all installations:
__—— =)
Flat-blade screwdriver
=eC—e
1/4" and 5/16" nut driver Level
(recommended)
Tape measure Pliers
Utility knife Tin snips (new vent
installations)
qo
Caulking gun and compound Adjustable wrench that
(new vent installations) opens to 1" (25 mm) or
hex-head socket wrench
—_>———
Min. 8" long Torx®t T25
screwdriver
(for door reversal only)
+ ® TORX is a registered trademark of Saturn Fasteners, Inc.
4
Tools needed for gas installations:
—U I)
8" or 10” pipe wrench 8" or 10" adjustable wrench
(for gas connections)
Pipe-joint compound
resistant to LP gas
Parts supplied:
Parts package is located in dryer drum. Check that all parts
are included.
NOTE: Do not use leveling legs supplied with dryer if installing
with a pedestal or a stack kit.
— |
Long inlet hose
Short inlet hose
Rubber washers
“Y¥” connector
Parts needed: (Not supplied with dryer)
@ Vent clamps
@ Vent elbows and ductwork
Additional parts may be required, depending in your installation.
Check local codes. Check existing electrical supply and venting.
Read “Electrical Requirements” and “Venting Requirements”
before purchasing parts.
Optional Equipment: (Not supplied with dryer)
Refer to your “Use and Care Guide” for information about
accessories available for your dryer.