Installation guide

28
Connect Drain Hose
Check the drain hose to see whether it is the proper length.
Wet the inside of the straight end of the drain hose with tap
water.
IMPORTANT: Do not use any lubricant other than water.
Squeeze ears of the silver double-wire clamp with pliers to
open. Place clamp over the straight end of the drain hose 1/4"
(6.4 mm) from the end.
Place hose into standpipe (shown in picture) or over side
of laundry tub.
IMPORTANT: 4.5" (114 mm) of drain hose should be inside
standpipe; do not force excess hose into standpipe or lay
on bottom of laundry tub. Drain hose form must be used.
1. Attach clamp to drain hose
¼"
(
6.4 mm)
3. Place drain hose in standpipe
4.5"
(114 mm)
Drain
hose form
Open clamp. Twist hose back and forth while pushing onto
drain connector at the lower left (27" [69 cm] models) or lower
center (24" [61 cm] models) portion of the rear of the washer/
dryer. Continue until hose contacts the ribbed stops on the
cabinet. On 27" (69 cm) models, place clamp over the area
on the hose marked “CLAMP.” On 24" (61 cm) models, place
clamp over the smooth area on the hose between the two ribs.
Release clamp.
2. Attach drain hose to drain connector
(27" [69 cm] model shown)
Proper connection of the drain hose protects your  oors
from damage due to water leakage. To keep the drain hose
from coming off or leaking, it must be installed according
to the following instructions:
IMPORTANT: To ensure proper installation, this procedure
must be followed exactly.
For  oor drain installations, you will need to remove the drain
hose form from the end of the drain hose. You may need
additional parts with separate directions. See “Tools and Parts.”
4. Remove drain hose form
( oor drain installations only)
The appearance of the
24" (61 cm) model will vary
1/4"
(6.4 mm)