Instruction for Use

ManualsBrandsWhirlpool ManualsDomestic AppliancesWH2010 A+E FO

INSTRUCTIONS FOR USE

A. Lid Handle.

B. Lock (if provided).

C. Seal.

D. Defrost water drain plug (depending on model).

E. Control panel.

F. Basket (depending on model).

G. Condenser (located at the rear).

INSTALLATION

• Refer to chapter “Before using the appliance”.

• Unpack the appliance.

• Remove the 4 protection pieces inserted between

lid and appliance.

• Warning: two of the four protection pieces must be

tted in the seat of the condenser plastic supports,

located at the rear of the product.

This is necessary to ensure the correct distance from

the wall.

• Ensure that the defrosting water drainage plug (if

provided) is correctly positioned (D).

• For best operation of the appliance and in order to avoid

damage when the lid is opened, leave a space of at least

7 cm from the rear wall and 7 cm at the sides.

• Fit the accessories (if provided).

•

Clean the inside of the appliance before using it.

1. Red LED: when ashing, it indicates that an alarm

condition is present (see “TROUBLESHOOTING

GUIDE”)

2. Blue LED: the function “6th Sense” is automatically

activated and does not need to be selected by the user,

therefore the blue LED (2) “Sense” always remains

on. For more technical details, refer to paragraph “6th

Sense function”.

3. Green LEDs: they indicate that the appliance is in

operation, and the temperature has been set.

4. Temperature setting button: to adjust the set

temperature and to activate/deactivate the fast freezing

operations.

Switching on the appliance

• Plug in the appliance.

• The green LED lights up (“Normal”).

• The blue LED lights up (“Sense”).

• The red LED ashes to indicate that the temperature

inside the appliance is not yet suciently low for food

storage. The red LED will normally switch o within the

rst six hours after the appliance is switched on.

• Place food inside the product only when the red LED has

switched o.

Note:

As the seal is tight, the appliance lid cannot be reopened

immediately after closing. Wait a few minutes before

re-opening the lid of the appliance.

Summary of content (4 pages)

PAGE 1
GB INSTRUCTIONS FOR USE • Ensure that the defrosting water drainage plug (if provided) is correctly positioned (D). • For best operation of the appliance and in order to avoid damage when the lid is opened, leave a space of at least 7 cm from the rear wall and 7 cm at the sides. • Fit the accessories (if provided). • Clean the inside of the appliance before using it. 1 A. Lid Handle. B. Lock (if provided). C. Seal. D. Defrost water drain plug (depending on model). E. Control panel. F.
PAGE 2
INSTRUCTIONS FOR USE Temperature adjustment Use the key (4) to select the desired temperature. To adjust the internal temperature, proceed as follows: • Repeatedly press the key (4). Each time the key is pressed, the set temperature is updated, displaying the “Normal”, “Eco” and “Max” values in succession. • Select “ Max” for a colder storage temperature. • With partial loads “Eco” is recommended: this setting will optimise energy consumption.
PAGE 3
INSTRUCTIONS FOR USE FOOD STORAGE Refer to the table on the appliance. Classification of frozen foods Put the frozen products into the appliance and classify them; The storage date should be indicated on the packs, to allow use within expiry dates. Advice for storing frozen food When purchasing frozen food products: • Ensure that the packaging is not damaged (frozen food in damaged packaging may have deteriorated).
PAGE 4
INSTRUCTIONS FOR USE • Has the appliance lid been left open for a long time? • Is the appliance placed in a very warm room or near heat sources? • Has the fast freeze function been activated? (The green LEDs flash alternatively) 7. Too much ice on the upper edge. • Are the defrost water drainage plugs correctly positioned? • Is the appliance lid properly closed? • Is the appliance lid seal damaged or deformed? (See chapter “Installation”) AFTER‑SALES SERVICE Before contacting After‑Sales Service: 1.