Instructions / Assembly

6
Installation Instructions
To Disconnect Tubing:
1. Push the collet inward and hold with a finger while pulling the tubing out.
tubing
collet (depress to remove tubing)
end of tubing round and smooth,
with no cuts, nicks or flat spots
correct full 11/16" engagement
Tubing correctly cut and connected
Incorrect partial engagement
Your water filtration system includes push-in fittings for quick tubing connection. Review the following
i
nstructions before connecting the tubes. Failure to follow these instructions may lead to future leaks.
Connect Tubing:
1. Use a tube cutter to cut the end of tubing square.
2. Inspect the end (about 1") of the tubing to be sure there are no nicks, scratches or other rough spots.
If needed cut the tubing again.
3. Push tubing through the collet and all the way into fitting. Full engagement is 11/16" length of tube
into the fitting.
FIG. 3
FIG. 4
Turn On Water, Check for Leaks and Rinse Carbon Fines
1. Open any shutoff valve(s) that you closed at the beginning of this installation.
2. Activate the refrigerator water dispenser to purge air from the system. When the water runs smooth,
with no bubbles or spurting, close faucet and check installation for leaks.
3. Let the water run for 10 minutes to rinse out carbon fines.
Make Tubing Connections