Use and Care Manual

6
INSTALLATION INSTRUCTIONS
1. Unpack the Air Conditioner
Remove Packaging Materials:
 Gently handle the air conditioner while unpacking the unit.
 Place the air conditioner on a hard, at surface.
 Remove tape and glue residue from surfaces before turning
ON the air conditioner. Rub a small amount of liquid dish soap
over the adhesive with the ngers. Wipe with a damp cloth
and dry.
 Do not use sharp instruments, rubbing alcohol, ammable
uids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of the air conditioner.
 Dispose of/recycle packaging materials in an appropriate way.
Prepare Air Conditioner for Installation
WARNING
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.
NOTES:
 This unit´s increased performance characteristics is the result
of having two rear intakes.
 It is very important that installation instructions are followed
so the unit can operate at maximum efciency.
 If there is an existing sleeve and rear grille, check whether the
dimension is suitable or not, otherwise replace them.
Existing Sleeves may have older single-sided intake grilles.
Single-sided intake grilles must be replaced with the dual intake
grille type as shown in the above gure.
 Remove the existing grille and save the mounting screws.
 Place the grille included with the new air conditioner towards
the inside rear of the sleeve.
 Attach the new grille by aligning the four mounting holes.
 Re-insert the self-tapping screws into the nylon retainers.
Left Intake
New Dual Intake Grille
Right Intake
3. Replacement of the Grill
2. Removal of the Grille
NOTE: Single intake grille must be removed when used with the
dual intake Through The Wall (TTW) unit.
IMPORTANT: While removing the grille, avoid it from falling
by securing with a leash. This can be fastened from cord or
strapping looped through the grille and secured with a knot as
shown in above figure.
While holding the grille by the leash with one hand, the retaining
screws can be removed and the grille can be brought inside
through the front of the sleeve as shown below.