Installation guide

COMPLETE INSTALLATION

CHECKLIST

Ɨ Check that all parts are now installed. If there is an extra

part, go back through steps to see what was skipped.

Ɨ Check that dryer is level. See “Level Dryer.”

Ɨ Check that you have all of your tools.

Ɨ Dispose of/recycle all packaging materials.

Ɨ Check dryer’s nal location.

Ɨ Remove lm on console and any tape remaining on dryer.

Ɨ Wipe dryer drum interior thoroughly with a damp cloth to

remove any dust.

Ɨ Read “Dryer Use” in your Use and Care Guide.

Ɨ For power supply cord installation, plug into a grounded

outlet. For direct wire installation, turn on power.

Ɨ Select a Timed Dry heated cycle and start dryer.

If dryer will not start, check the following:

• Controls are set to a running or On position.

• Start button has been pressed rmly.

• Dryer is plugged into an outlet and/or electrical

supply.

• Household fuse is intact and tight or circuit breaker

has not tripped.

• Dryer door is closed.

This dryer automatically runs an installation diagnostic routine

at the start of its rst cycle.

NOTE: You may notice an odor when dryer is rst heated.

This odor is common when heating element is rst used.

The odor will go away.

#2 Phillips screwdriver

Min. 8" (203 mm) long

TORX

, T20

and T25

†

screwdrivers

Tools needed:

†

TORX, T20, and T25 are registered trademarks of Acument Intellectual Properties, LLC.

DOOR REVERSAL (OPTIONAL)

The following instructions are for models with round doors.

1. Disconnect wiring from door

Using a Phillips screwdriver, remove middle screw in hinge.

Disconnect wiring. Tuck wiring into opening.

DOORS WITH LCD SCREEN: