Installation guide

19
10. Reposition rotating assembly
and tubing
Reposition rotating assembly and tubing 180 ° to opposite side
of the door.
11. Rotate assembly bottom and fasten
in place
Rotate bottom of assembly 180° towards you and secure
assembly with the two screws removed earlier, using a Phillips
screwdriver. Press tubing into indents.
IMPORTANT: Make sure to swing hinge down in front of
rotating assembly (see Step 12).
Press tubing
into indents.
12. Reinstall inner door assembly
Position the door with the inside of the door facing up. Using
a Phillips screwdriver, reinstall the 10 screws removed earlier,
securing the inner door to the outer door.
13. Reinstall door on dryer
Doors with electrical wiring: Pull the wire through the front
panel opening before reinstalling the door.
Insert the tabs on the hinge into the mounting slot and slide
down to engage the top tab. Secure in place with the
four T25
®
screws removed earlier.
Bottom
of door
ALL DOORS:
Swing
down