Installation guide

4
LOCATION REQUIREMENTS
Check codes requirements. Some codes limit, or do not permit,
installing dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
You will need:
■ A separate 30 A circuit.
■ If using a power supply cord, a grounded electrical outlet
located within 2 ft. (610 mm) of either side of dryer. See
“Electrical Requirements.”
■ Floor must support dryer weight of 200 lbs. (90.7 kg). Also
consider weight of companion appliance.
■ Level oor with maximum slope of 1" (25 mm) under entire
dryer. If forward slope is greater than 1" (25 mm), water could
run out from front of lter. Install Extended Dryer Feet Kit, Part
Number 279810. If not level, clothes may not tumble properly
and automatic sensor cycles may not operate correctly.
■ For garage installation, place dryer at least 18" (460 mm)
above oor. If using a pedestal, you will need 18" (460 mm)
to bottom of dryer.
■ The dryer must not be installed or stored in an area where it
will be exposed to water and/or weather.
IMPORTANT: Do not operate, install, or store dryer where
it will be exposed to water, weather, or at temperatures below
40°F (4°C). Lower temperatures may cause dryer to not
shut off at end of automatic sensor cycles, resulting in longer
drying times.
DRYER DIMENSIONS
27"
(686 mm)
38
3
/4" Min.
(984 mm)
39" Max.
(990 mm)
Front view:
Side view:
51 " min.
(1314 mm)
31 " min.
(806 mm)
Back view:
13
1
/2"
(343 mm)
6
1
/2"
(165 mm)
6
1
/2"
(165 mm)
29
7
/8"*
(759 mm)
NOTE: Allow
clearance behind
dryer for proper
drain hose routing
and cooling fan
ventilation. Push
dryer back as
far as possible
and make sure
drain hose is not
crushed or kinked.
*Approx. measurement
Water
drain
Cooling
fan
IMPORTANT: Do not block cooling fan, as your dryer may not
operate properly.
Power cord/
cable
54
1
/2"
(1378 mm)
31"
(787 mm)
5
3
/4"
(146 mm)