Instructions / Assembly

11
Faucet Electronics
Troubleshooting the System
Need help troubleshooting? Call Toll Free 1-866-986-3223 or visit whirlpoolwatersolutions.com
Faucet Timer
Inside the faucet base is a battery operated 6 month timer.
An amber LED indicator is also located in the front of the faucet base. This LED will flash continuously
after 6 months have passed. This indicates that it is time to replace the battery and filters.
Battery Change
To change the battery, complete the following steps.
1. Loosen the screw on the right side of the faucet base.
2. Press the battery housing upwards from faucet base
until it releases from the base.
3. Replace the battery (CR 2032 or equivalent). Place
battery into the holder with the positive (+) side facing
the back of the holder.
NOTE: Recycle or properly dispose of the old battery.
4. When the battery is first replaced the light in the base
will flash six times and turn off. This indicates the bat-
tery is fully charged. After the six flashes the timer
enters the 6 month time cycle. If it repeatedly flashes
two times, the battery is weak and needs to be replaced.
5. Re-install the battery housing and firmly tighten the
mounting screw.
FIG. 8
battery
housing
screw
battery,
negative (-) side
facing the front
Problem: No water or decreased water flow.
Cause: Filter 1 is clogged. Correction: Replace the filter 1 cartridge.
Cause: Flow through the microbiological purifying filter will
decrease and eventually clog when exposed to an
excess of microbiological loading materials in the water.
This failsafe feature reduces the chance of product use
beyond its intended life, and will shut down the filter
when it is exposed to contaminated water.
Correction: Replace all filter cartridges.
Problem: Taste and/or Odor.
Cause: Filter cartridges exhausted. Correction: Replace all filter cartridges.
Cause: System contaminated. Correction: Sanitize system. Call 1-866-986-3223
for instructions.
Problem: Faucet LED indicator light does not function after battery change.
Cause: Battery dead. Correction: Replace with new battery.
Cause: Battery installed incorrectly. Correction: Install battery correctly.
Problem: Water leaks at push connect fittings.
Cause: Tubing not pushed in all the way. Correction: Push tubing in all the way into fittings.
Cause: Tubing not cut square. Correction: Cut tubing square.
Cause: Tubing nicked. Correction: Remove nicked portion, reinsert tubing
into fitting.
Cause: Outer tubing surface not smooth. Correction: Remove rough portion, reinsert tubing
into fitting.