Specifications

Step 3: Install RO Filter Assembly

FIG. 11

INSTALL REVERSE OSMOSIS FILTER

ASSEMBLY

The Reverse Osmosis Filter Assembly is mounted on

hanger washers.

See Fig 11. The hanger washers allow you to lift the filter

assembly from the washers without any hardware

removal. When planning your installation, you need to

leave room for changing filters.

Complete the following steps to install your Reverse

Osmosis Filter Assembly:

1. Remove the cover.

2. Locate mounting slots on back inside of the assembly.

See Fig 11.

3. Hold the assembly up to the wall surface and mark

locations for the hanger washers. See Fig 11. This

allows room to change filters.

4. Fasten the hanger washers to the wall using the wood

screws provided.

5. Hang assembly on washers.

6. Replace cover.

Questions? Visit www.whirlpool.com or call Toll Free 1-866-986-3223

Screw (2)

Hanger Washer (2)

9''

15-1/2'' Minimum Up from

Floor. This distance allows

for space to change filters