Specifications

13
Step 5: Install RO Faucet
FIG. 15
FIG. 14
BLACK TUBE
3/8” barb fitting
for the black tube
RED TUBE
1/4” barb fitting
for the red tube
BLUE TUBE
3/8” quick connect
fitting for the blue
tube
Faucet
Body
Faucet
Base
Rubber
Gasket
Toggle Bolts
Screw holding
the battery
housing in
place
Timer Housing
Amber LED
INSTALL REVERSE OSMOSIS FAUCET
1. Locate and organize your RO faucet install parts. Refer to
Fig. 14.
2. Mount faucet base to sink hole until the faucet base is
square against the sink surface. The rubber gasket should
be between the sink surface and the faucet base.
3. Tighten the toggle bolts until the base is firmly mounted to
the sink surface. Do not overtighten.
4. Locate the faucet base. (The black and blue tubes are
already connected to the faucet.) Insert these tubes into
the sink hole until approximately one foot of tube length
and the faucet base are left above the counter
surface. Do not bend or kink the tubes in the process.
See Fig. 13 and 22.
5. Locate the 1/4" red tubing. One end is connected to the
RO Filter assembly. See Fig 22. Locate the loose end.
A. Route red tube through countertop to faucet.
B. Cut the loose end of the red tube square and to length.
See Fig. 22.
Note: Tubing lengths should allow for the removal of the
assembly from the hanger washers for servicing. If tub-
ing lengths are shortened for neater appearance, it may
be necessary to keep the assembly on the hanger wash-
ers for service.
C. Insert all the way onto the 1/4" faucet barb fitting on
faucet. See Fig. 15.
D. Pull on the tubing to be sure it is held firmly in the fit-
ting.
NOTE: If you ran the red reverse osmosis drain tubing
directly to a remote drain point, disregard step 3 and
refer to instructions on page 9.
6. Mount the faucet body on to the faucet ba
se, 1/4 turn.
FAUCET ELECTRONICS
Inside the faucet base is a battery operated 6 month timer.
See Fig. 14.
An amber LED indicator is also located in the front of the
faucet base. This LED will flash continuously after 6 months
has passed. This indicates that it is time to replace the
battery, prefilters and postfilters.
INSTALL BATTERY
To install battery, complete the following steps.
1. Loosen the screw on the right side of the faucet base.
See Fig. 14.
2. Press the battery housing upwards from the front faucet
base until it releases from the faucet base. See Fig. 14.
3. Replace the battery (CR 2032 or equivalent). Place the
positive (+) side down into the holder.
4. When the battery is first replaced it will flash six times and
turn off. This indicates the battery is fully charged. After the
six flashes the timer enters the 6 month time cycle. If it
repeatedly flashes just two times, it is not a fully charged
battery and will need to be replaced.
5. Re-install the timer housing and firmly tighten the mounting
screw. See Fig. 14.
Battery
Housing
Battery,
negative (-)
side facing
out
Faucet
Base
Screw