Specifications

Customizing Features/Options-- Model WHES30

Recharge

Recharge button is used to initiate an immediate recharge.

• Press and hold the

RECHARGE button until the words “RECHARGE”, “SERVICE”

and “FILL” flash in the display, and the softener enters the fill cycle of regeneration right

awa y. The word “ RECHARGE” will flash during the regeneration. When ove r, full water

conditioning c apacity is restored.

RECHARGE NOW Initiated

NOTE:

Avoid using hot water while the conditioner is regenerating, because the water heater will

refill with bypass hard water.

Recharge Scheduled

If you do not want to start an imme diate recharge, but would like an extra re charge at the next pr eset

recharge time, do the following to schedule a recharge.

• Press and release (do not hold) the

RECHARGE button. The words “ RECHARGE

SCHEDULED” flashes in the display, and the softener will recharge at the next recharge

time. The w ord “RECHARGE” will f lash during the regeneration. W hen over, full wa ter

conditioning c apacity is restored.

SetSaltLevel

The water softener has a salt monitor indicator light to remind you to refill the storage tank with salt.

• To set this monitor system, lift the salt hole cover and level the salt in the storage tank.

The salt level decal, on the brinewell inside the tank, has numbers from 0 to 8. Observe

the number the leve led salt is at, or closest to. Now, press the

SET SALT LEVEL

button until black ova ls c orespond to the salt level number. At level 2 or below, the

indicator LED will flash “Check Salt Level”.

• If you want to turn the salt monitor off, press the SET SALT LEVEL button until

“SALT LEVEL OFF” shows in display.