Specifications

26
Maximum Days Between Regenerations
The wate r softener automatically controls regeneration frequency. This provides the gre atest operating
efficien cy, and under most conditions, this feature should be left in this mode. However, modify this
feature if you want to force a regeneration every set number of days. For example, if your water supply
contains iron and you want the softener to regenerate at least once every few days to keep the resin
bed clean, set the display as shown below. Setting is available from 1 to 15 days by using the UP and
DOW N buttons.
NOTE: The softener will r echarge on its own if needed, even if it is before the set number of days.
1. Press and hold the
PROGRAM button until the following screen is displayed.
Once in this display, press the PROGRAM button four times and f ollowing display is shown.
2. Press the
+
Up or
−
Down buttons to set number of days.
12 or 24 Hour Clock
All time displays are shown in standar d clock time (1 to 12 PM; and 1 to 12 AM) at the 12 hr de fault
setting. If 24 hour clock displays are desired, follow steps below.
1. Press and hold the
PROGRAM button until the following screen is displayed.
Once in this display, press the PROGRAM button five times and the following display is
shown.
12 Hour Clock Initiated 24 Hour Clock Initiated
2. Press the
+
Up or
−
Down buttons to set clock.
If you have questions about installation, pr ogramming, operating and routine maintenance...
call 1--866--986--3223, Monday -- Friday, 8 am to 9 pm, EST.