Troubleshooting guide

Set Water Hardness Number

1. Press the PROGRAM button once again to display a flashing 25 and the word

“HARDNESS” .

HARDNESS

2. Press the Up or Down buttons to set your water hardness number.

NOTE: If your water supply contains iron, compensate f o r it by adding to the water hardness

number. For example, assume your water is 20 gpg hard and contains 2 ppm iron. Add

5 to the hardness number for each 1 ppm of iron. In this example, you would use 30

for your hardness number.

20 gpg hardness

2ppmironx5=10 +10

(times) 30 HARDNESS NUMBER

Start a Recharge

Press the RECHARGE button and hold for three se conds until Recharge begins to flash in the

timer display, starting a recharge. This recharge draws the sanitizing bleach into and through the water

softener. Any air remaining in the water softener is purged to the drain.

If you have questions about installation, programming, operating and routine maintenance...

call 1--866--986--3223, Monday -- Friday, 8 am to 9 pm, EST.