Installation Guide

14
Programming the Water Softener
c
ontinued from previous page
3. Be sure to set the correct salt type, depending on
w
hich type of salt is used (NaCl or KCl). Use the
r UP or s DOWN buttons to toggle between
NaCl and KCl, then press the PROGRAM button to
enter the selection.
4. Press the PROGRAM button once again to return
to normal operating display.
Questions about installing or operating your water softener? Call Toll Free 1-866-986-3223
Monday- Friday, 8 AM - 7 PM EST or visit www.whirlpoolwatersofteners.com
When you call, please be prepared to provide the model and serial number,
found on the rating decal, typically located on the rim below the salt lid hinges.