® IC4 Side-by-Side Refrigerator Ice Maker Kit Installation and Operating Instructions Keep these instructions for future reference. Be sure this manual stays with the ice maker.
Introduction Parts ! CAUTION Use listed part numbers only when ordering replacement parts. Part numbers are not used in installation instructions. To avoid personal injury or property damage, observe all safety instructions. Verify proper ice maker kit model, listed on wiring diagram on back of refrigerator. Read entire manual before installing kit. All necessary tools and materials must be available prior to installation. Verify all listed parts are included in kit.
Materials Required Important • Before connecting ice maker, contact a plumber to connect copper tubing to household plumbing in compliance with local codes and ordinances. • Amana Appliances recommends using a saddle valve. Do not use self-piercing valve. Amana Appliances is not responsible for property damage due to improper installation or water connection. 1 /4" (6 mm) outside diameter flexible copper tubing*.
10. Replace upper vertical cover by placing cover on refrigerator. Carefully tuck wires inside cover to avoid pinching wires. Insert and tighten screws with a 1/4" hex nut driver. 11. Remove tape from end of copper tubing. Put end of copper tubing into sink or bucket. Slightly turn on water supply to refrigerator. Water will be under considerable pressure. Allow water to run through copper tubing for 1 minute to flush out copper tubing. Shut off water supply to refrigerator when flushing is complete. 12.
24. Built-In Models (SB******) Remove and discard button plugs above ice maker with a putty knife covered with masking tape. All Other Models Remove and discard button plugs below ice maker with a putty knife covered with masking tape. 25. Confirm stop pin locking fingers are unlocked. Center drive pin must extend 1/2" (13 mm) on opposite side of locking fingers. If not pull out center drive or use a screwdriver to push center drive pin out 1/2" (13 mm). 32.
Before Calling For Service Allow ice maker 1 overnight period to make ice before assuming a difficulty exists. If ice maker is not producing ice • Confirm ice maker arm is down. • Confirm household water supply is reaching water valve. • Confirm ice maker wiring harness plug is completely inserted into electrical receptacle. • Check for kinks in copper or plastic tubing. Remove kinks or replace tubing. • Check electrical connections to water valve coil. • Confirm freezer is operating at proper temperature.
Part No. 10527037 Printed in U.S.A.
