Before you start... Unlape and open washer lld Remove Hot and have everylhlng necessary for correct cold waler faucets: must be wIthin 4 feet of the bock of the washer and provide water pressure 51CO PSI Check locai~on where washer WIII be lnslalled Proper installation 1s your responslblllty Make sure “0~ Laundry tub drain system: needs a 20.
Now Start... with Washer In laundry Area. \ 1~ Remove tape that covers m shipping strap. Pull to completely remove the shipplng strap from the inside of the washer. Read. then remove lobe that covers power cord and drain connector. Peel the tape down ond off each side of cabinet. ;i;; c. “\ 2fi? * LY-r 1.
19 front corner washer. Da 15. of washer not tiahten Tilt washer backward corner post(s). Gently floor. until nuts touch nuts until steo 17 CHECK ELECTRICAL n REQUIREMENTS. SE SURE YOU HAVE CORRECT ELECTRICAL SUPPLYAND RECOMMENDED GROUNDING METHOD. ond remove lower wosherto Move washer to Its permanent location. 20 Check that 011 parts are W now installed. See parts list, Panel A. If there is an edra part.
Numbers correspond to steps.
Recessed area instructions. This washer may be installed in a recessed area of closet. The installation spacing is in inches and is minimum allowable. Additional spacing should be considered for ease of installation and servicing. If closet door is installed, the minimum air openings in top and bottom are required. Louvered doors with air openings in top and bottom are acceptable. Companion appliance spacing should be considered.