Top Loading Washing Machine WMTF722HUK
1 a b c 2 d g g e f 3 B 4 C A D 5 6 7 8 A 9 A 10 11 12 13 14 15 The brands Ariston, Hotpoint Ariston and Hotpoint differ by sales territory.
17a 17b 19 20 23 24 25 26 27 28 29 30 18 21 B 22 A
INTENDED USE This washing machine is exclusively destined to wash and spin machine washable laundry in quantities which are usual for private households. • Observe the instructions given in these Instructions for Use and the Programme Chart when using the washing machine • Keep these Instructions for Use and the Programme Chart; if you pass on the washing machine to another person, also give him/her Instructions for Use and Programme Chart. SAFETY AND GENERAL RECOMMENDATIONS 1.
BEFORE USING THE WASHING MACHINE 1. Remove the packaging and check a. Cut and remove the shrink-wrap. b. Remove the top protection and the protective corners. c. Remove the bottom protection by tilting and turning the washing machine on one rear bottom corner. Make sure that the plastic part of the bottom protection (if available on the model) remains in the packing and not in the machine bottom. This is important, as otherwise the plastic part could damage the washing machine during operation. d.
DESCRIPTION OF THE WASHING MACHINE (picture 1) a. b. c. d. e. f. Mobility lever (depending on model). To move the washing machine: pull the handle out a little bit by hand and pull it out to the stop with the foot. g. Adjustable feet Lid Detergent dispenser Drum Pump access behind filter After-Sales Service sticker (behind the filter cover) INSTALLATION Removal of transport bracket The washing machine is fitted with a transport bracket to avoid any possible damage during transport.
ELECTRICAL CONNECTION Do not use extension leads or multi sockets. Electrical connections must be made in accordance with local regulations. 1) Warning - this washing machine must be earthed This washing machine is normally supplied with a mains lead having a plug fitted in the factory which has been checked for correct earth continuity.
BEFORE THE FIRST WASH CYCLE To remove any residual water used in testing by the manufacturer, we recommend that you carry out a short wash cycle without laundry. 1/3 of the quantity the detergent manufacturer recommends for lightly soiled laundry) to the main wash chamber of the detergent dispenser. 4. Close the lid. 5. Select and start programme “Synthetics” at 60°C (see separate the programme chart). 1. Open the tap. 2. Close the drum flaps. 3.
DETERGENTS AND ADDITIVES Keep detergents and additives in a safe, dry place out of the reach of children. Do not use any solvents (e.g. turpentine, benzene); do not machine wash fabrics that have been treated with solvents or flammable liquids. Only use detergents and/or additives that are specifically produced for domestic washing machines. Observe the recommendations on the care labels of your laundry. Please note: Too much detergent can result in excess foam formation, which reduces washing efficiency.
CARE AND MAINTENANCE Always unplug the washing machine before doing any maintenance. Detergent dispenser Water inlet hose Clean the detergent dispenser regularly, at least three or four times a year, to prevent detergent build-up: (picture 21, 22 or 23, depending on model) Detergent dispenser - picture 17a 1. Push in the buttons on each side of the dispenser (picture 18). 2. Pull the dispenser towards you and remove it. A small quantity of water can remain in the dispenser.
Recovering an object that falls between the drumand the tub If an object accidentally falls between the drum and the tub, you can recover it thanks to one of the removable drum blades: 1. Unplug the washing machine. 2. Remove the laundry from the drum. 3. Close the drum flaps and turn the drum a half-turn (picture 24). 4. Using a screw-driver, press on the plastic end while sliding the blade from left to right (picture 25, 26). 5. It will fall into the drum. 6.
AFTER SALES SERVICE No one is better placed to care for your Hotpoint appliance during the course of its working life than us - the manufacturer. Essential Contact Information Hotpoint Service We are the largest service team in Europe offering you access to 400 skilled telephone advisors and 1000 fully qualified engineers on call to ensure you receive fast, reliable, local service. UK: 08448 224 224 Republic of Ireland: 0818 313 413 www.hotpointservice.co.
TROUBLESHOOTING GUIDE Your washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and allow you to react appropriately. These faults are frequently so minor that they can be removed within a few minutes. Problem Causes - Solutions - Tips Appliance does not start, no indicator lamps are on • Plug is not properly inserted in socket. • Socket or fuse does not function correctly (use a table lamp or similar appliance to test it).
Description of failure indicators Failure indicator lights up Indication on display (if available) “bdd” (in case your washing machine has no display: all lamps of the programme flow bar light up) from “F02” to “F35” (except “F09”) “Clean pump” Appliance stops during the programme. “Drum flaps open” (the drum flaps have not been closed properly). Push the “Reset” button for at least 3 seconds and wait until the “Door open” lights up.
EN W10735888 08/2014