Owner's Manual
Table Of Contents
- BUILT-IN MICROWAVE/OVEN COMBO SAFETY
- Built-In Microwave/Oven Combination Safety
- MICROWAVE OVEN MAINTENANCE AND CARE
- General Cleaning
- Self-Cleaning Cycle
- Steam Clean (On Some Models)
- INSTALLATION INSTRUCTIONS
- REQUIREMENTS
- Tools and Parts
- Location Requirements
- Electrical Requirements
- INSTALLATIONS
- Prepare Built-In Oven
- Remove Oven Door(s)
- Replace Oven Door(s)
- Make Electrical Connection
- Install Oven
- Complete Installation
- SECURITE DE L'ENSEMBLE FOUR ELECTRIQUE/FOUR A MICRO-ONDES ENCASTRE
- Securite de l'ensemble four electrique/four a micro-ondes encastre
- ENTRETIEN ET REPARATION DU FOUR A MICRO-ONDES
- Nettoyage general
- Programme d'autonettoyage
- Steam Clean (nettoyage a la vapeur) (sur certains modeles)
- INSTRUCTIONS D'INSTALLATION
- SPECIFICATIONS
- Outils et pieces
- Exigences d'emplacement
- Specifications electriques
- INSTALLATION
- Preparer le four encastre
- Enlever la/les porte(s) du four
- Reinstallation de la/des porte(s) du four
- Raccordement electrique
- Installation du four
- Achever l'installation
14
5. The bottom vent and bottom vent shield are shipped in the
foam packing at the top of the oven.
Long bottom vent trims are used when the oven is installed
with the feet in the tall position. Please contact service for one
to be shipped to you free of charge.
■ Align vent tab (B) with oven frame (A) as shown.
■ Using one #8-18 x 3/8" (9.5 mm) screw (C) on each side of
the vent tab (B), fasten the vent securely to the oven frame
(A).
A. Oven frame
B. Vent tab
C. #8-18 x 3/8" screws
6. After the bottom vent shield is installed.
■ Align the Bottom vent tab (B) with the oven frame (A) as
shown.
■ Using one #8-18 x 3/8" (9.5 mm) screw (C) on each side of
the vent tab (B), align the top of the bottom vent tab (B) to
the Hinge receiver (D) as shown.
■ Fasten the bottom vent securely to the oven frame (A).
A. Oven frame
B. Vent tab
C. #8-18 x 3/8" (9.5 mm)
screw
D. Hinge receiver
7. Replace the oven racks.
8. Replace the oven door. See the “Replace Oven Door(s)”
section.
9. Check that the door is free to open and close. If it is not,
repeat the removal and installation procedures. See the
“Prepare Built-In Oven” section.
10. Repeat for lower oven door.
11. Reconnect power.
12. The display panel will light briefly, and “PF” should appear in
the display.
13. If the display panel does not light, refer the Warranty.
C
B
A
A
C
B
D
B