Installation Instructions

16
Install Warming Drawer Deflector Kit
(Only for Ovens Installed Above Warming Drawers)
On single and double oven models installed above a warming
drawer, a warming drawer deflector kit must be installed. See
the “Tools and Parts” section for information on ordering.
Parts Supplied in Deflector Kit
Install Deflector Kit
1. Flex the upper vent piece (C) away from the lower vent piece
(D) to slide the warming drawer deflector (B) between them.
Some force may be required to flex the upper vent trim (C)
away from the lower vent trim (D). Some force may also be
required to flex the warming drawer deflector (B) and slide
it into position. Make sure screw holes are properly aligned
between the two pieces. See the following illustration.
2. Install the warming drawer deflector (B) to the lower
vent piece (D) using two #8-18 x 1/4" (6.4 mm) screws
on each side.
NOTE: On 27" (68.6 cm) models, only one #8-18 x 1/4"
(6.4 mm) screw is used on each side.
3. Align vent tab (B) with oven frame (A) as shown
in the following illustration.
4. Using one #8-18 x 3/8" (9.5 mm) screw (E) on each side of
the vent tab (B), fasten the vent securely to the oven.
Complete Installation
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For oven use and cleaning, read the Use and Care Guide.
Check Operation of Single and Double Ovens
1. At first use, set up the language, clock, and any other
preferences if available. For more information, read the Use
and Care Guide.
2. Press OVEN on single oven models.
NOTE: Press UPPER or LOWER on double oven models.
3. Select Cooking Methods.
4. Select Broil.
5. Set the temperature.
6. Select Start.
If Oven(s) Does Not Operate, Check the Following:
■ Household fuse is intact and tight, or circuit breaker
has not tripped.
■ Electrical supply is connected.
■ See the “Troubleshooting” section in the Use and
Care Guide.
7. When oven has been on for 5 minutes, feel for heat.
If you do not feel heat or if an error message appears in the
display, turn off the oven and contact a qualified technician.
8. Press UPPER or LOWER on double ovens, or press OVEN
on single ovens, to cancel.
If You Need Assistance or Service:
Please reference the “Warranty” section of the Use
and Care Guide.
B
A
A. Phillips head screws (4)
only 2 screws for 27" (68.6 cm) size
B. Warming drawer deflector (1)
D
B
A
C
B
D
C
A. #8-18 x 1/4" (6.4 mm) screws
B. Warming drawer deflector
C. Upper vent piece
D. Lower vent piece
A
C
D
B
E
A. Oven frame
B. Vent tab
C. Oven vent
D. Warming drawer deflector
E. #8-18 x 3/8" (9.5 mm)
screw