Specification
Table Of Contents
- BUILT-IN MICROWAVE/OVEN COMBINATION SAFETY
- Built-In Microwave/Oven Combination Safety
- MICROWAVE OVEN MAINTENANCE AND CARE
- General Cleaning
- Self-Cleaning Cycle
- Steam Clean (On Some Models)
- INSTALLATION INSTRUCTIONS
- REQUIREMENTS
- Tools and Parts
- Location Requirements
- Electrical Requirements
- INSTALLATIONS
- Prepare Built-In Oven
- Remove Oven Door(s)
- Make Electrical Connection
- Install Oven
- Install Warming Drawer Deflector Kit
- Replace Oven Door(s)
- Complete Installation
- SECURITE DE L'ENSEMBLE FOUR ELECTRIQUE/FOUR A MICRO-ONDES ENCASTRE
- Sécurité de l’ensemble four électrique/four à micro-ondes encastré
- ENTRETIEN ET REPARATION DU FOUR A MICRO-ONDES
- Nettoyage général
- Programme d’autonettoyage
- Steam Clean (nettoyage à la vapeur) (sur certains modèles)
- INSTRUCTIONS D'INSTALLATION
- SPECIFICATIONS
- Outils et pièces
- Exigences d’emplacement
- Spécifications électriques
- INSTALLATION
- Préparer le four encastré
- Enlever la/les porte(s) du four
- Raccordement électrique
- Installation du four
- Installer l’ensemble de déflecteurs pour tiroir-réchaud (uniquement pour les fours installés par-dessus des tiroirs-réchauds)
- Réinstallation de la/des porte(s) du four
- Achever l’installation
- SEGURIDAD DE LA COMBINACION DE HORNO MICROONDAS/HORNO INTEGRADO
- Seguridad de la combinación de horno de microondas/horno integrado
- MICROWAVE OVEN MAINTENANCE AND CARE
- Limpieza general
- Ciclo de autolimpieza
- Steam Clean (Limpieza con vapor) (en algunos modelos)
- INSTRUCCIONES DE INSTALACION
- REQUISITOS
- Herramientas y piezas
- Requisitos de ubicación
- Requisitos eléctricos
- INSTALACIONES
- Preparación del horno empotrado
- Retire las puertas del horno
- Hacer la conexión eléctrica
- Para instalar el horno
- Instale el kit de deflector para cajón de calentamiento (solo para hornos instalados encima de un cajón de calentamiento)
- Vuelva a colocar las puertas del horno
- Finalización de la instalación
14
11. Reconnect power.
12. The display panel will light briefly, and “PF” should appear in
the display.
13. If the display panel does not light, refer the Warranty.
14. If F9E0 error code is encountered upon powering up the
The oven feet need to be installed to allow a microwave/oven
combination to be installed in a recommended cutout height of
42
1
/
2
" (107.9 cm).
NOTE: Do not remove the spacers.
A. Spacers
1. Using 2 or more people, place the on its back on a covered
surface.
2. Install a foot on the left rear spacer using a #8-18 x 3/8" screw.
NOTE: Position the foot so the long side of the foot is facing
toward the top of the oven.
A. Spacers
B. Foot
C. #8-18 x 3/8" screw.
3. In the same manner, install a foot on the right rear of the oven.
4. Install a front foot on the left front spacer using a #8-18 x 3/8"
NOTE: Position the foot so the long side of the foot is facing
toward the inside of the oven.
A. Front foot
B. #8-18 x 3/8" screw.
C. Spacer
5. In the same manner, install a front foot on the right front of the
oven.
Positioning Oven Feet
unit, the appliance is wired incorrectly at the Junction Box or
Electrical Panel. Contact a qualified electrician to verify the
home electrical supply and the hardwire connection at the
Junction Box or Electrical Panel (See the Electrical
Connection Options section).