Installation Guide

14
11. Reconnect power.
12. The display panel will light briefly, and “PF” should appear in
the display.
13. If the display panel does not light, refer the Warranty.
14. If F9E0 error code is encountered upon powering up the
The oven feet need to be installed to allow a microwave/oven
combination to be installed in a recommended cutout height of
42
1
/
2
" (107.9 cm).
NOTE: Do not remove the spacers.
A. Spacers
1. Using 2 or more people, place the on its back on a covered
surface.
2. Install a foot on the left rear spacer using a #8-18 x 3/8" screw.
NOTE: Position the foot so the long side of the foot is facing
toward the top of the oven.
A. Spacers
B. Foot
C. #8-18 x 3/8" screw.
3. In the same manner, install a foot on the right rear of the oven.
4. Install a front foot on the left front spacer using a #8-18 x 3/8"
NOTE: Position the foot so the long side of the foot is facing
toward the inside of the oven.
A. Front foot
B. #8-18 x 3/8" screw.
C. Spacer
5. In the same manner, install a front foot on the right front of the
oven.
Positioning Oven Feet
unit, the appliance is wired incorrectly at the Junction Box or
Electrical Panel. Contact a qualified electrician to verify the
home electrical supply and the hardwire connection at the
Junction Box or Electrical Panel (See the Electrical
Connection Options section).