Installation Guide
Table Of Contents
- BUILT-IN MICROWAVE/OVEN COMBINATION SAFETY
- Built-In Microwave/Oven Combination Safety
- MICROWAVE OVEN MAINTENANCE AND CARE
- General Cleaning
- Self-Cleaning Cycle
- Steam Clean (On Some Models)
- INSTALLATION INSTRUCTIONS
- REQUIREMENTS
- Tools and Parts
- Location Requirements
- Electrical Requirements
- INSTALLATIONS
- Prepare Built-In Oven
- Remove Oven Door(s)
- Make Electrical Connection
- Install Oven
- Install Warming Drawer Deflector Kit
- Replace Oven Door(s)
- Complete Installation
- SECURITE DE L'ENSEMBLE FOUR ELECTRIQUE/FOUR A MICRO-ONDES ENCASTRE
- Sécurité de l’ensemble four électrique/four à micro-ondes encastré
- ENTRETIEN ET REPARATION DU FOUR A MICRO-ONDES
- Nettoyage général
- Programme d’autonettoyage
- Steam Clean (nettoyage à la vapeur) (sur certains modèles)
- INSTRUCTIONS D'INSTALLATION
- SPECIFICATIONS
- Outils et pièces
- Exigences d’emplacement
- Spécifications électriques
- INSTALLATION
- Préparer le four encastré
- Enlever la/les porte(s) du four
- Raccordement électrique
- Installation du four
- Installer l’ensemble de déflecteurs pour tiroir-réchaud (uniquement pour les fours installés par-dessus des tiroirs-réchauds)
- Réinstallation de la/des porte(s) du four
- Achever l’installation
- SEGURIDAD DE LA COMBINACION DE HORNO MICROONDAS/HORNO INTEGRADO
- Seguridad de la combinación de horno de microondas/horno integrado
- MICROWAVE OVEN MAINTENANCE AND CARE
- Limpieza general
- Ciclo de autolimpieza
- Steam Clean (Limpieza con vapor) (en algunos modelos)
- INSTRUCCIONES DE INSTALACION
- REQUISITOS
- Herramientas y piezas
- Requisitos de ubicación
- Requisitos eléctricos
- INSTALACIONES
- Preparación del horno empotrado
- Retire las puertas del horno
- Hacer la conexión eléctrica
- Para instalar el horno
- Instale el kit de deflector para cajón de calentamiento (solo para hornos instalados encima de un cajón de calentamiento)
- Vuelva a colocar las puertas del horno
- Finalización de la instalación
15
6. Using 2 or more people, place the oven in its upright position.
7. Go to the “Make Electrical Connection” section in the
Installation Instructions provided with your built-in oven.
Install Warming Drawer Deflector Kit
(Only for Ovens Installed Above
Warming Drawers)
On single and double oven models installed above a warming
drawer, a warming drawer deflector kit must be installed. See the
“Tools and Parts” section for information on ordering.
Parts Supplied in Deflector Kit
B
A
A. Phillips head screws (4), only 2 screws for 27"
(68.6 cm) size
B. Warming drawer deflector (1)
Install Deflector Kit
1. Install the warming drawer deflector (B) to the lower vent
piece (D) using two #8-18 x 1/4" (6.4 mm) screws on each
side.
NOTE: On 27" (68.6 cm) models, only one #8-18 x 1/4"
(6.4 mm) screw is used on each side.
B
A
C
D
A. #8-18 x 1/4"
(6.4 mm)
screws
B. Warming
drawer
deflector
C. Upper vent piece
D. Lower vent piece
2. Align vent tab (B) with oven frame (A) as shown in the
following illustration.
3. Using one #8-18 x 3/8" (9.5 mm) screw (E) on each side of the
vent tab (B), fasten the vent securely to the oven.
E
D
C
B
A
A. Oven frame
B. Vent tab
C. Oven vent
D. Warming drawer deflector
E. #8-18 x 3/8" (9.5 mm)
screw