Specification
Table Of Contents
- BUILT-IN OVEN SAFETY
- Built-In Oven Safety
- OVEN MAINTENANCE AND CARE
- General Cleaning
- Self-Cleaning Cycle
- Steam Clean
- INSTALLATION INSTRUCTIONS
- REQUIREMENTS
- Tools and Parts
- Location Requirements
- Electrical Requirements
- INSTALLATIONS
- Prepare Built-In Oven
- Remove Oven Door(s)
- Positioning Oven Feet for Multiple Cabinet Cutout Heights
- Make Electrical Connection
- Install Oven
- Install Warming Drawer Deflector Kit (Only for Ovens Installed Above Warming Drawers)
- Replace Oven Door(s)
- Complete Installation
- SECURITE DU FOUR ENCASTRE
- Securite du four encastre
- ENTRETIEN ET REPARATION DU FOUR
- Nettoyage general
- Programme d'autonettoyage
- Nettoyage a la vapeur
- INSTRUCTIONS D'INSTALLATION
- SPECIFICATIONS
- Outils et pieces
- Exigences d'emplacement
- Specifications electriques
- INSTALLATION
- Preparer le four encastre
- Enlever la/les porte(s) du four
- Positionner les pieds du four pour des ouvertures de decoupe dans l'armoire
- Raccordement electrique
- Installation du four
- Installer l'ensemble de deflecteurs pour tiroir-rechaud (uniquement pour les fours installes par-dessus des tiroirs-rechauds)
- Reinstallation de la/des porte(s) du four
- Achever l'installation
- SEGURIDAD DEL HORNO INTEGRADO
- Seguridad del horno integrado
- MANTENIMIENTO Y CUIDADO DEL HORNO
- General Cleaning
- Ciclo de autolimpieza
- Steam Clean
- INSTRUCCIONES DE INSTALACION
- REQUISITOS
- Tools and Parts
- Location Requirements
- Requisitos electricos
- INSTALACIONES
- Preparacion del horno empotrado
- Retire las puertas del horno
- Ubicacion de las patas del horno para multiples alturas de corte del armario
- Como hacer la conexion electrica
- Install Oven
- Instale el kit de deflector para cajon de calentamiento (solo para hornos instalados encima de un cajon de calentamiento)
- Vuelva a colocar las puertas del horno
- Finalizacion de la instalacion
15
6. Using 2 or more people, place the oven in its upright position.
7. Go to the “Make Electrical Connection” section.
Double Ovens
The positioning of the oven feet allow a double oven to be
installed in a cutout height between 48
7
/
8
" and 52
3
/
16
" (124.1 cm
and 132.6 cm). Refer to the following instructions to position the
feet for the size of your cabinet cutout.
Cutout Height is Between 48
7
/
8
" and 50
7
/
16
" (124.1 cm and
128.1 cm)
The oven feet do not need to be installed. The oven is configured
correctly as received.
NOTE: Do not remove the spacers.
Go to the “Make Electrical Connection” section.
A. Spacers
Cutout Height is Between 50
1
/
2
" and 51
1
/
8
" (128.2 cm and
129.9 cm) or for Flush Installation
1. Using 2 or more people, place the oven on its back on a
covered surface.
2. Install a rear foot on the left rear spacer using a #8-18 x 3/8"
(9.5 mm) screw.
NOTE: Position the foot so the long side of the foot is facing
toward the top of the oven.
A. Spacer
B. Rear foot
C. #8-18 x 3/8" (9.5 mm) screw
3. In the same manner, install a rear foot on the right rear of the
oven.