Installation Instruction

2
BUILT-IN OVEN SAFETY
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting
installation. Read and follow the instructions provided
with any tools listed here.
Tools Needed
■ Phillips screwdriver
■ Measuring tape
■ Hand or electric drill (for wall cabinet installations)
■ 1” (2.5 cm) drill bit (for wall cabinet installations)
■ Level
■ Flat-blade screwdriver
Parts Needed
■ UL Listed or CSA Approved conduit connector
■ UL Listed wire connectors
■ Warming Drawer Deflector Kit (for ovens installed above a
warming drawer):
Color Size Type Warming Drawer
Deflector Kit
White 27” Single / Double W10510613
White 30” Single / Double W10510614
Black 27” Single / Double W10531009
Black 30” Single / Double W10531010
SS 27” Single / Double W10536338
SS 30” Single / Double W10536339
BSS 27” Single / Double W10888988
BSS 30” Single / Double W10727416
Bronze 30” Single / Double W11123007
To order, see the “Assistance or Service” section of the Use and
Care Guide.
■ Flush Installation Kit (for Single and Double installed at flush
installation):
Color Size Type Flush Installation
Kit
White 27” Single / Double W11173681
White 30” Single / Double W11173683
Black 27” Single / Double W11173685
Black 30” Single / Double W11173691
SS 27” Single / Double W11173693
SS 30” Single / Double W11123003
BSS 27” Single / Double W11173700
BSS 30” Single / Double W11173703
Bronze 30” Single / Double W11123005
To order, see the “Assistance or Service” section of the Use and
Care Guide.
Parts Supplied
■ #8-14 x 3/4” (19 mm) screws: single ovens (2), double ovens
(4)
■ #8-18 x 3/8” (9.5 mm) screws: bottom vent (2)
■ #8-18 x 1/4” (6.4 mm) screws: bottom vent trim (4)
■ #8-18 x 3/8” (9.5 mm) screws: double oven feet (4)
■ Bottom vent
■ Bottom vent trim
■ Rear feet: double oven (2)
■ Front feet: double oven (2)
Check local codes. Check existing electrical supply. See the
“Electrical Requirements” section.
It is required that all electrical connections be made by a
licensed, qualified electrical installer.
You can be killed or seriously injured if you don't immediately
You
can be killed or seriously injured if you don't
follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING