Instruction for Use

Whirlpool is a registered trademark of Whirlpool USA
Before using the dishwasher, read the
installation and maintenance instructions carefully!
1
GB
5019 396 01166
WP 93
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads,
extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness and power supply voltage.
2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories:
for more detailed information on the
EN comparison test and other tests, contact the following address: “[e-mail]”.
3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with. Standard NF EN 13697
- November 2001.
1. OVERVIEW
ON button
OFF button
Programme selection button
Press button P (repeatedly) until the required programme number
appears on the display.
Fault indication and wash time display
In normal operation it indicates the remaining time (h:mm),
whereas with “Delayed start” selected it indicates the time
remaining until programme start (hh).
In the presence of a fault indication “F..” –, consult the section “5.
What to do if …”.
An acoustic signal sounds as long as the error persists.
Rinse aid level indicator and salt level indicator
They light up when rinse aid or salt need to be added.
Add just before starting a wash cycle.
Set the detergent
Press button P (repeatedly) to set the type of detergent used.
This deactivates the rinse aid and/or salt indicator.
Half Load/Multizone button
Load the
upper or lower rack only.
Press once = wash
upper rack
(the indicator/symbol lights up)
Press twice = wash
lower rack
(the indicator/symbol lights up)
Press 3 times =
Off
(Half load/Multizone deactivated).
When washing without the upper rack, press the “Half load” (i.e.
“wash lower rack”) button. “twice (the corresponding indicator/
symbol lights up).
Powder, gel, tablets (standard): indicator off
Detergent with rinse aid: left indicator
Detergent with salt + rinse aid: right indicator
Rotating Power Clean
High pressure with an additional jet for better washing results and
greater bottom rack load flexibility.
“Delayed start” button
Press the button (repeatedly) to delay the start of the programme.
Adjustable from 1 to 24 hours. With each press of the button, the
delayed start indicator increases by one hour and after 24 restarts
from 00. Then press the START button. The dishwasher will start
after the set time.
START button
The indicator lights up during operation, flashes when a fault
occurs, and goes off at the end of the programme.
RESET button - for programme change or indication of faults
Press this button to cancel a started programme and selected
extra functions. Press this button to cancel the main fault
indicators (F..); also refer to the section “5. What to do if...”. The
programme can then be selected and started.
Running programme indicator
A LED light projected on the floor indicates that the dishwasher is
working.
Table 1.1.
Table of programmes
Detergent
dispenser
Consumption
1)
P
Programmes
Available
options
Loading instructions large small Litres kWh Minutes
1
Sensor + 40-70°C
Normally or heavily soiled
crockery, including pots and
pans.
X X 7-15 0.99-1.75 65-205 ±
1)
2
Pre-Rinse cold
Crockery to be washed later.
— — 4.0 0.03 14 ±
1)
3
Glasses 40°C
Light soiling, for example
glasses and cups.
X — 10.0 0.85 100 ±
1)
4
Quickwash 45°C
Lightly soiled crockery, without
dry residuals.
X — 11.0 0.80 30 ±
1)
5
Eco
2)
50°C
Normally soiled crockery.
Energy-saving programme.
X X 11.0 1.05 170 ±
1)
6
Hygienic +
3)
Normally or heavily soiled
crockery, with additional
antibacterial action. An
interruption of the programme
(e.g. due to door opening) can
compromise elimination of germs.
X X 13.0 1.50 115 ±
1)
7
Nightrinse 55°C
Normally soiled crockery,
gentle and quiet (39 dbA)
thanks to the lower pressure
jet.
X X 13.0 1.20 290 ±
1)