Installation Instructions

9
17. Plug into a grounded 3 prong outlet
COMPLETE INSTALLATION CHECKLIST
q
Check electrical requirements. Be sure you have correct
electrical supply and recommended grounding method.
q
Check that all parts are now installed. If there is an extra part,
go back through steps to see what was skipped.
q
Check that you have all of your tools.
q
Check that transport materials were completely removed from
back of washer.
q
Check that both hot and cold hoses are attached and water
faucets are on.
q
Check for leaks around faucets, valves, and inlet hoses.
q
Remove protective lm from console and any tape
remaining on washer.
q
Check that washer is plugged into a grounded
3 prong outlet.
q
Dispose of/recycle all packaging materials.
q
Read “Using Your Washer” in your Washer Use and Care
Guide.
q
To test and clean your washer, press POWER and choose the
Quick cycle and run it without clothes. Use only HE
detergent. Use 1/2 the manufacturer’s recommended amount
for a medium-size load.
If washer is not level, use a 9/16" (14 mm) open-end or
adjustable wrench to turn jam nuts clockwise on feet until
they are about 1/2" (13 mm) from the washer cabinet.
Then turn the leveling foot clockwise to lower the washer
or counterclockwise to raise the washer. Do not exceed 2"
(50 mm) from bottom of foot to bottom of cabinet. Recheck
levelness of washer and that all four feet are rmly in contact
with the oor. Repeat as needed.
HELPFUL TIP: You may want to prop up front of washer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer.
When washer is level and all four feet are rmly in contact with
the oor, use a 9/16" (14 mm) open-end or adjustable wrench
to turn jam nuts counterclockwise on leveling feet tightly
against washer cabinet.
HELPFUL TIP: You may want to prop washer with
wooden block.
15. Adjust leveling feet
Jam nut
16. Tighten leveling feet
Jam nut