Owners Manual
Table Of Contents
- REFRIGERATOR SAFETY
- Refrigerator Safety
- REFRIGERATOR CARE
- Cleaning
- Changing the LED Module
- Refrigerator Shelves
- Opening and Closing Doors
- Vacation and Moving Care
- INSTALLATION INSTRUCTIONS
- Unpack the Refrigerator
- Location Requirements
- Electrical Requirements
- Water Supply Requirements
- Connect the Water Supply
- Complete the Installation
- Install Air Filter (on some models)
- Install Produce Preserver (on some models)
- REFRIGERATOR FEATURES
- Crisper Humidity Control (on some models)
- Water and Ice Dispensers (on some models)
- Ice Maker and Storage Bin
- Water Filtration System
- DOOR AND HANDLE INSTRUCTIONS
- Door and Drawers
- Remove and Replace Handles
- Remove Refrigerator Doors and Hinges
- Reset Bottom Refrigerator Door Hinge
- Replace Refrigerator Doors and Hinges
- Remove and Replace Refrigerator Drawer
- Door Closing and Alignment
- PERFORMANCE DATA SHEET
- Performance Data Sheet
- SÉCURITÉ DU RÉFRIGÉRATEUR
- Sécurité du réfrigérateur
- ENTRETIEN DU RÉFRIGÉRATEUR
- Nettoyage
- Remplacer le module à DEL
- Tablettes du réfrigérateur
- Ouverture et fermeture des portes
- Précautions à prendre avant les vacances ou le déménagement
- INSTRUCTIONS D’INSTALLATION
- Déballage du réfrigérateur
- Exigences d’emplacement
- Spécifications électriques
- Spécifications de l’alimentation en eau
- Raccordement à la canalisation d’eau
- Terminer l’installation
- Installer le filtre à air (sur certains modèles)
- Installation du conservateur de produits frais (sur certains modèles)
- CARACTÉRISTIQUES DU RÉFRIGÉRATEUR
- Commande d’humidité dans le bac à légumes (sur certains modèles)
- Distributeur d’eau et de glaçons (sur certains modèles)
- Machine à glaçons et bac d’entreposage
- Système de filtration de l’eau
- INSTRUCTIONS POUR LA PORTE ET LA POIGNÉE
- Porte et tiroirs
- Pour enlever et réinstaller les poignées
- Démontage des portes et charnières du réfrigérateur
- Réinitialiser la charnière inférieure du réfrigérateur
- Réinstallation des portes et charnières
- Retrait et réinstallation du tiroir de congélation
- Fermeture et alignement des portes
- FICHE DE DONNÉES DE PERFORMANCE
- Fiche de données de performance
25
Front Style 3
1. Slide the drawer glides out of the freezer compartment.
2. Insert the screws in the top of the drawer into the slots in the
drawer brackets.
3. Completely tighten all four screws.
Door Closing and Alignment
The base grille covers the adjustable brake feet and roller
assemblies located at the bottom of the refrigerator below the
freezer drawer. Before making any adjustments, remove the base
grille and move the refrigerator to its final location.
Tools Needed: 1/4" hex driver Tools Provided: 1/8" hex key
1. Remove base grille.
BASE GRILLE
Style 1
� Using both hands, grasp the grille firmly and pull it toward
you. Open the freezer drawer to access the brake feet.
NOTE: To allow the refrigerator to roll easier, raise the
brake feet by turning them counterclockwise. The front
rollers will be touching the floor.
Style 2
� Remove the two screws fastening the base grille to the
cabinet and set screws aside.
� Grasp the grille and pull it toward you.
NOTE: To allow the refrigerator to roll easier, raise the
brake feet by turning them counterclockwise. The front
rollers will be touching the floor.
Style 3
� Use a 1/4” hex–nut driver to remove both screws in the
base grille.
� Using both hands, grasp the grille firmly and pull it toward
you. Open the freezer drawer to access the brake feet.
NOTE: To allow the refrigerator to roll easier, raise the
brake feet by turning them counterclockwise. The front
rollers will be touching the floor.
2. Move the refrigerator to its final location.
3. Make sure the doors close easily. If you are satisfied with the
door opening and closing, skip the next section and go to
“Align the Doors.” If, however, the doors do not close easily or
the doors pop open, adjust the tilt.
4. Using a 1/4” hex driver, lower the brake feet. Turn them
clockwise until the rollers are off the floor and both brake feet
are snug against the floor. This keeps the refrigerator from
rolling forward when operating the refrigerator doors freezer
drawer.
IMPORTANT: If you need to make further adjustments
involving the brake feet, you must turn both brake feet the
same amount to keep the refrigerator level.
5. Use a level to make sure the refrigerator is level from side to
side and front to back.
6. Make sure the doors are even at the top and that the space
between the bottom of the refrigerator doors and the top of the
freezer drawer is even. If necessary, align the doors.
To Adjust the Cabinet Tilt:
1. Open the freezer drawer. Use a 1/4" hex driver to turn both
brake feet clockwise the same amount. This will raise the front
of the refrigerator. It may take several turns to allow the doors
to close easier.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the brake feet. This makes it
easier to turn them.