Owner's Manual

Table Of Contents
26
Step 1 - Adjust the Drawer Fronts Up/Down
IMPORTANT: Each refrigerated drawer can be adjusted up and
down on both the left and the right sides.
Tools Needed: Phillips screwdriver
1. With the drawers closed, identify the drawer front that needs
to be raised or lowered.
2. Open the drawer to its full extension, and remove the interior
bin.
3. Locate the drawer glide brackets.
A. Drawer glide brackets
4. Insert the Phillips screwdriver into tightening screw and turn
counterclockwise to loosen the drawer front.
A. Tightening screw B. Adjusting screw
5. Insert the Phillips screwdriver into adjusting screw to adjust
the drawer front.
IMPORTANT: The direction you turn the adjusting screw
depends on which side of the drawer you are adjusting.
Left-Hand Side Drawer Glide
To raise the drawer front, turn adjusting screw clockwise.
To lower the drawer front, turn adjusting screw
counterclockwise.
Right-Hand Side Drawer Glide
To raise the drawer front, turn adjusting screw
counterclockwise.
To lower the drawer front, turn adjusting screw clockwise.
6. Insert the Phillips screwdriver into tightening screw, and turn
clockwise to tighten the drawer front.
7. Close the refrigerated drawer to check the alignment. Repeat
steps 2 through 6 until the drawer fronts are level.
Step 2 - Adjust the Drawer Fronts Side to Side
IMPORTANT: Each refrigerated drawer can be adjusted side to
side on both the left and right side.
1. With the drawers closed, identify the drawer that is not
aligned.
2. Open the drawer to its full extension, and remove the interior
bin.
3. Locate the drawer glide brackets.