Dispensing Guide

3
CRISPER DRAWER REMOVAL AND REPLACEMENT
To remove the drawer:
1. Push the drawer completely closed.
2. Lift up the front of the drawer and pull it straight out.
To replace the drawer:
1. Push the metal glide rails to the rear of the refrigerator.
2. Place the drawer onto the glide rails. While tilting the rear of the
drawer upward, slide the drawer toward the rear of the
refrigerator.
CRISPER DRAWER DIVIDER
To remove the divider:
1. Pull the drawer out to its full extension.
2. Lift the front of the divider and lift the divider out.
To replace the divider:
1. Position the divider so that the features on the bottom of the
divider align with the matching features in the drawer.
2. Lower the divider into place.
Additional Control Panel Descriptions
DOOR AJAR ALARM
The Door Ajar Alarm feature sounds an alarm when the
refrigerator door(s), drawers, or freezer drawer is open
for 5 minutes and cooling is turned on. The alarm will
repeat every 2 minutes. Close all doors and drawer to
turn it off. The feature then is reset and will reactivate
when either door is left open again for 5 minutes.
NOTE: To mute the audible alarm while keeping the doors open,
such as while cleaning the inside of the refrigerator, press any
button on the control panel. The alarm sound will be temporarily
turned off, but the Door Ajar icon will still be displayed on the
dispenser control panel.
DISABLING SOUNDS
� To turn off control and dispenser sounds, press and hold Ice/
Water and Fast Ice at the same time for 3 seconds. All normal
operating tones are disabled. Only alert tones will be audible.
� To turn all sounds back on, press and hold Ice/Water and Fast
Ice at the same time for 3 seconds again.
SHOWROOM MODE
This mode is used only when the refrigerator is on display in a retail
store. If you unintentionally turn on Showroom mode, the words
Showroom Mode will light up on the display. Exit Showroom mode
by pressing and holding Light and Lock at the same time for 3
seconds.