Owners Manual

21
9. Close the refrigerator door to align and reinstall the top hinge.
Use a TORX T30 screwdriver to tighten the screws as shown
below.
A. Do not remove A screws
IMPORTANT: Provide additional support for the door while top
hinge is being reinstalled. Do not depend on the door magnets
to secure the door to the cabinet.
Door Closing and Alignment
Your refrigerator has two front adjustable wheels.
These are used to level the refrigerator under uneven floor
conditions or to allow the doors to close more easily. Please follow
the instructions below:
1. Use a bubble level to check levelness of floor where the rear
side of the refrigerator will rest. If the refrigerator is not
leveled, adjust or add the shim on flooring to create a leveled
floor for the rear side wheels. A leveled rear side prevents the
refrigerator cabinet from forming a twist.
2. Place the refrigerator into its final location in the kitchen and
open both doors.
3. Fully open both doors.
4. If your model has water dispensing, please open the water
filter door by pulling it toward you as shown below. It is not
necessary to remove the water filter itself.
5. Pull the base grille toward you from the sides and then from
the center until it dislodges.
6. To remove the base grille, twist and pull the right side until this
side passes underneath the refrigerator door. Then pull the left
side of the base grille for complete removal.
A. Pull to the right for
extraction
B. Twist and pass
underneath door
7. Raise the wheels while one person pushes on the refrigerator
to lift from front side. Use the bubble level on top of the
refrigerator or on its side to level the refrigerator. Check
bubble level and at the same time observe the gaps and
squareness to the adjacent cabinets, furniture, or trim. If
adjacent furnishings are not level, it may not be possible to
achieve even gaps when refrigerator is level. Continue
adjusting until all four corners are steady without rock.
8. Use a 3/8" nut driver to turn the leveling screws located in both
sides of the refrigerator as shown below. Depending on
uneven floor conditions, you must turn one or both screws to
the right or left several times to raise or lower the refrigerator.
9. Close both doors and check that they close as easily as you
like. If not, turn both screws to the right to raise the refrigerator
by tilting it more to the back until the doors close as easily as
you like.
10. Check and make sure that the technician sheet is placed in
the base grille cavity before assembling the base grille into the
cabinet.
11. Reinstall the base grille into the cabinet, introducing the left
side first and then the right side of the base grille as shown
below. You may accommodate the water dispenser tubing and
wiring into base grille cavity below the left bottom hinge.
12. Attach the base grille by pushing it into the cabinet clips.
Door Alignment
The refrigerator doors are designed to be slightly misaligned
vertically when the refrigerator is empty. If the doors are uneven
after food has been placed, please follow the next instructions:
1. Use an 11/16" open-ended wrench to loosen the locking nut
located below the refrigerator door as shown below.
Accommodate the wrench so that it fits in the space.
2. Use a 5/16" open-ended wrench tool to turn the alignment
screw as shown below. Depending on how the refrigerator
door is misaligned in relation to the freezer door, you must turn
the screw to the right to raise or to the left to lower the
refrigerator door until both doors have been aligned vertically.
3. Tighten the 11/16" locking nut with the wrench.
4. Attach the base grille if it was dislodged.