Installation Instructions

11
Installing the tubing clips
Refer to the side diagrams for the following steps.
1. Remove the hex-head screws from the rear access cover,
then remove the cover and set it aside.
NOTE: If you have a later unit with a metal panel, and a
separate, smaller access cover (see DETAIL A), remove the
hex-head screw from the access cover. Discard the cover
and its screw. Do not remove the hex-head screws from the
larger rear access cover.
2. Peel the backing from the adhesive sides of the tubing clips.
Press the clips against the back of the cabinet in the right
channel at the approximate locations shown in DETAIL B.
Center the clips between the ll tube and the top of the
access opening. Alternate ll tube design is shown in
DETAIL C.
3. For side by side models with a metal access cover, install
the water valve bracket to the mounting holes in the cabinet
frame using two 1/2" machine screws. See DETAIL D.
Installing the tubing clips
DETAIL A
Remove
hexhead
screw from rear
access cover
Metal panel
DETAIL D
Remove
hexhead screws
from rear
access cover
Access cover
1/2" hex-head
machine screws
DETAIL C
Alternate
ll tube
design
Tubing Clip
DETAIL B
Right channel
Fill tube