Service Manual
Table Of Contents
For Service Technician Use Only
DIAGNOSTICS
Whirlpool
®
, Maytag
®
, Amana
®
, & IKEA
®
Refrigerators
n
2-7
Step Step Code Component Acon Feedback
27
●
LED1
O
LED2
O
LED3
●
LED4
O
LED5
Water Paddle Entry: Display step number.
Do: User to press water paddle. Service
user to monitor the display feedback.
Exit: N/A.
Paddle Pressed:
●
LED6
O
LED7
O
LED8
O
LED9
O
LED10
NOTE: No water is dispensed in
this step.
28 OFF NONE OFF OFF
29
●
LED1
O
LED2
●
LED3
O
LED4
O
LED5
Ice harvest RC Feedback informaon
1. Blank = Unl get a valid
reading
O
LED6
O
LED7
O
LED8
O
LED9
O
LED10
2. IM harvest cycle is ON
●
LED6
O
LED7
O
LED8
O
LED9
O
LED10
3. IM harvest cycle is OFF
●
LED6
●
LED7
O
LED8
O
LED9
O
LED10
4. Ice bucket full detected
●
LED6
●
LED7
●
LED8
O
LED9
O
LED10
5. Ice bucket not full
●
LED6
●
LED7
●
LED8
●
LED9
O
LED10
6. Switch faulty or motor
(Timeout = 20 seconds)
●
LED6
●
LED7
●
LED8
●
LED9
●
LED10
30 OFF NONE OFF OFF
31
●
LED1
●
LED2
O
LED3
●
LED4
O
LED5
Ice maker
water ll test
Entry: Display step number. Upon entry
to this step, there will be a 3 seconds
delay, and then the ice tray will be
moved to the home posion.
Do: Aer the tray has reached home
posion, the "CHANGE SETTING KEY"
will start an ice maker ll (only 100 ml
+/- 10). Service user to monitor the
display feedback.
Exit: Clear feedback informaon.
NOTE: At step entry the water ll
cycle default to OFF. Prior entry of this
run step 29, make sure the ice tray is
empty. Before proceeding with water
ll, otherwise, double ll will occur.
Make sure to proceed with step 29
aer water ll test to leave tray empty
when nishing service. Ice bucket must
be in place to run this test.
RC Feedback informaon
1. Conguraon to start
O
LED6
O
LED7
O
LED8
O
LED9
O
LED10
2. Ice tray moving to the home
posion
●
LED6
O
LED7
O
LED8
O
LED9
O
LED10
3. Water ll OFF
●
LED6
●
LED7
O
LED8
O
LED9
O
LED10
4. Water ll ON
●
LED6
●
LED7
●
LED8
O
LED9
O
LED10
32 OFF NONE OFF OFF