ECO Owner's Manual

4
2. Press a sturdy glass against the dispenser lever. Hold the glass
close to the ice guide to ensure that the ice dispenses into the
glass.
IMPORTANT: You do not need to apply a lot of pressure to the lever
in order to activate the ice dispenser. Pressing hard will not make
the ice dispense faster or in greater quantities.
3. Remove the glass to stop dispensing.
NOTE: Ice may continue to dispense for several seconds after
removing the glass from the lever. The dispenser
may continue to
make noise for a few seconds after dispensing.
The Dispenser Light
When you use the dispenser, the light will automatically turn on.
If you want the light to be on continuously, press
LIGHT.
Press LIGHT again to turn the dispenser light off.
The dispenser lig
more information.
The Dispenser Lock
The dispenser can be turned off for easy cleaning or to avoid
unintentional dispensing by small children and pets.
NOTE: The lock feature does not shut off power to the refrigerator, to
the ice maker, or to the dispenser light. It simply deactivates the
controls and dispenser lever. To turn off the ice maker, see “Ice Maker
and Storage Bin.”
Press and hold LOCK for 3 seconds to lock the dispenser.
Press and hold LOCK a second time to unlock the dispenser.
The display screen indicates when the dispenser is locked.
Ice Maker and Storage Bin
Allow 24 hours to produce the first batch of ice. Discard the first
three batches of ice produced.
The quality of your ice will be only as good as the quality of the
water supplied to your ice maker. Avoid connecting the ice maker to
a softened water supply. Water softener chemicals (such as salt)
can damage parts of the ice maker and lead to poor quality ice. If a
softened water supply cannot be avoided, make sure the water
softener is operating properly and is well maintained.
Do not use anything sharp to break up the ice in the storage bin.
This can cause damage to the ice container and the dispenser
mechanism.
Do not store anything on top of or in the ice maker or storage bin.
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
WARNING
A. Water dispenser lever
B. Water dispenser spout
C. Ice dispenser lever
D. Ice guide
To turn on the ice maker, lift open the ice maker door and lower
the wire shutoff arm to the On position
To manually
turn off the ice maker, lift the wire shutoff arm to the
Off (arm up) position and listen for the click. Ice can still be
dispensed, but no more can be made.
The ice maker has an automatic shutoff to keep the
s
ing during normal operation. As ice is
m
and the ice
cubes will raise the wire shutoff arm to the Off (arm up) position.
Do not force the wire shutoff arm up or down.
Removing and Replacing the Ice Storage Bin
ift the wire shutoff arm so it clicks into the Off (up) position.
e bin and pull it out.
n all the way or the dispenser will
not work.
To restart ice production, lower the wire shutoff arm into the
O
.
.
A
C
B
D
1.
2.
3.
4.
5.
2
To turn on the ice maker, lift open
the ice maker door
switch to the On (right) position.
To manually turn off the ice maker, lift open the ice maker
he switch to the Off (left) position. Ice can still be
dispensed, but no more can be made.
accessed by lifting and opening the ice maker door.
NOTE: Your ice maker has an automatic shutoff to keep the storage
As ice is made, the ice
cubes will the ice storage bin, and the ice cubes will raise the
shutoff arm to the Off (arm up) position. When the storage bin is at
full capacity, the ice maker will automatically stop ice production,
but the ice maker On/Off switch will remain in the On position.
“Troubleshooting” for