Owner's Manual
Table Of Contents
- REFRIGERATOR SAFETY
- Refrigerator Safety
- MAINTENANCE AND CARE
- Cleaning
- Lights
- Freezer Shelf (number varies by model)
- Vacation and Moving Care
- INSTALLATION INSTRUCTIONS
- Unpack the Refrigerator
- Location Requirements
- Electrical Requirements
- Water Supply Requirements
- Connect Water Supply
- Complete the Installation
- Install Air Filter (on some models)
- Install Produce Preserver (on some models)
- REFRIGERATOR FEATURES
- Convertible Drawer Temperature Control (on some models)
- Crisper Humidity Control (on some models)
- Dual Evaporator (on some models)
- Water and Ice Dispensers
- Ice Maker and Storage Bin
- Water Filtration System
- DOOR REMOVAL AND LEVELING STYLE 1
- Door Instructions
- Install and Remove Door Handles
- Remove Doors and Hinges
- Replace Doors and Hinges
- Door Closing and Alignment
- DOOR REMOVAL AND LEVELING STYLE 2
- Door Instructions
- Install and Remove Door Handles
- Remove Doors and Hinges
- Door Closing, Leveling, and Alignment
- PERFORMANCE DATA SHEET
- Performance Data Sheet
- SÉCURITÉ DU RÉFRIGÉRATEUR
- Sécurité du réfrigérateur
- ENTRETIEN ET RÉPARATION
- Nettoyage
- Lampes
- Tablettes du congélateur (le nombre varie selon le modèle)
- Précautions à prendre avant les vacances ou le déménagement
- INSTRUCTIONS D’INSTALLATION
- Déballage du réfrigérateur
- Exigences d’emplacement
- Spécifications électriques
- Spécifications de l’alimentation en eau
- Raccordement à la canalisation d’eau
- Terminer l’installation
- Installer le filtre à air (sur certains modèles)
- Installation du conservateur de produits frais (sur certains modèles)
- CARACTÉRISTIQUES DU RÉFRIGÉRATEUR
- Commande de température dans le tiroir convertible (sur certains modèles)
- Commande d’humidité dans le bac à légumes (sur certains modèles)
- Évaporateur double (sur certains modèles)
- Distributeurs d’eau et de glaçons
- Machine à glaçons et bac d’entreposage
- Système de filtration de l’eau
- RETRAIT DE LA PORTE ET AJUSTEMENT DU NIVEAU, STYLE 1
- Instructions pour la porte
- Installation et retrait des poignées de la porte
- Démontage des portes et charnières
- Réinstallation des portes et charnières
- Fermeture et alignement des portes
- RETRAIT DE LA PORTE ET AJUSTEMENT DU NIVEAU, STYLE 2
- Instructions pour la porte
- Installation et retrait des poignées de la porte
- Démontage des portes et charnières
- Fermeture, mise à niveau et alignement des portes
- FICHE DE DONNÉES DE PERFORMANCE
- Fiche de données de performance
21
4. If your model has water dispensing in the door, connect the
water dispenser tubing. For the connection, push the tubing
into the dispenser tubing until black mark touches the face of
fitting as shown below.
A. Face of fitting
5. Connect the wiring as shown below.
A. Wiring plugs C. Grommets
B. Wiring clip
6. Reinstall the wiring clip & the bracket wire using a 1/4"
hexagonal head socket wrench.
7. Connect the wiring plugs from the bracket wire.
8. Lift the refrigerator door enough to insert the door onto the
bottom hinge pin as shown below.
IMPORTANT: Hold the door while hinge is being installed.
9. Close the refrigerator door to align and reinstall the top hinge.
Use a TORX T30 screwdriver to tighten the screws as shown
below.
A. Do not remove A screws
IMPORTANT: Provide additional support for the door while top
hinge is being reinstalled. Do not depend on the door magnets
to secure the door to the cabinet.
Door Closing and Alignment
Your refrigerator has two front adjustable wheels.
These are used to level the refrigerator under uneven floor
conditions or to allow the doors to close more easily. Please follow
the instructions below:
1. Use a bubble level to check levelness of floor where the rear
side of the refrigerator will rest. If the refrigerator is not
leveled, adjust or add the shim on flooring to create a leveled
floor for the rear side wheels. A leveled rear side prevents the
refrigerator cabinet from forming a twist.
2. Place the refrigerator into its final location in the kitchen and
open both doors.
3. Fully open both doors.
4. If your model has water dispensing, please open the water
filter door by pulling it toward you as shown below. It is not
necessary to remove the water filter itself.
5. Pull the base grille toward you from the sides and then from
the center until it dislodges.
6. To remove the base grille, twist and pull the right side until this
side passes underneath the refrigerator door. Then pull the left
side of the base grille for complete removal.
A. Pull to the right for
extraction
B. Twist and pass
underneath door
7. Raise the wheels while one person pushes on the refrigerator
to lift from front side. Use the bubble level on top of the
refrigerator or on its side to level the refrigerator. Check
bubble level and at the same time observe the gaps and
squareness to the adjacent cabinets, furniture, or trim. If
adjacent furnishings are not level, it may not be possible to
achieve even gaps when refrigerator is level. Continue
adjusting until all four corners are steady without rock.
8. Use a 3/8" nut driver to turn the leveling screws located in both
sides of the refrigerator as shown below. Depending on
uneven floor conditions, you must turn one or both screws to
the right or left several times to raise or lower the refrigerator.
9. Close both doors and check that they close as easily as you
like. If not, turn both screws to the right to raise the refrigerator
by tilting it more to the back until the doors close as easily as
you like.