Owner's Manual

12. If your refrigerator without doors does not pass through the

doorway, you may remove both bottom hinges. Use a 5/16"

nut driver to remove these as shown below..

B. Do not remove B screws

IMPORTANT: Do not remove either screw B.

Replace Doors and Hinges

If your doors and bottom hinges have been removed, please

follow the next instructions for reinstallation:

1. Reinstall both bottom hinges using a 5/16" nut driver to tighten

screws as shown below.

B. Do not remove B screws

2. If your model has water dispensing in the door:

� Lift the freezer door enough to feed the water dispenser

tubing and wiring through the bottom hinge pin as shown

below.

NOTE: This may require two people, one to lift the door

and the other to feed the water tubing and wiring into the

bottom hinge pin.

IMPORTANT: Hold the door while hinge is being installed.

3. Close the freezer door to align and reinstall the top hinge. Use

a TORX T30 screwdriver to tighten the screws as shown

below.

A. Do not remove A screws

IMPORTANT: Provide additional support for the door while top

hinge is being reinstalled. Do not depend on the door magnets

to secure the door to the cabinet.

4. If your model has water dispensing in the door, connect the

water dispenser tubing. For the connection, push the tubing

into the dispenser tubing until black mark touches the face of

fitting as shown below.

A. Face of fitting

5. Connect the wiring as shown below.

A. Wiring plugs C. Grommets

B. Wiring clip

6. Reinstall the wiring clip & the bracket wire using a 1/4"

hexagonal head socket wrench.

7. Connect the wiring plugs from the bracket wire.

8. Lift the refrigerator door enough to insert the door onto the

bottom hinge pin as shown below.

IMPORTANT: Hold the door while hinge is being installed.