Installation Instruction

18
8. Bend the copper tubing to meet the water line inlet, located
on the back of the refrigerator cabinet as shown. Leave a coil
of copper tubing to allow the refrigerator to be pulled out of
the cabinet or away from the wall for service.
Connect to Refrigerator
Follow the connection instructions specic to your model.
1. Remove plastic cap from water valve inlet port. Attach the
copper tubing to the valve inlet using a compression nut
and sleeve as shown. Tighten the compression nut. Do not
overtighten. Conrm copper tubing is secure by pulling on
copper tubing.
2. Create a service loop with the copper tubing. Avoid kinks
when coiling the copper tubing. Secure copper tubing to the
rear panel with a “P” clamp, using the original screw in the
panel slot above the valve.
3. Turn on water supply to refrigerator and check for leaks.
Correct any leaks.
A
B
C
D
A. Copper tubing
B. “P” clamp
C. Compression nut
D. Compression sleeve