Manualshelf

Dimension Guide

ManualsBrandsWhirlpool ManualsAppliances30 Inch Top Freezer Refrigerator, in Monochromatic Stainless Steel
12
1
Model
Number
Model Size Reversible Door
Height Overall
"A"
Height - Top of
Cabinet "B"
Depth - Door
Open 90° "C"
Depth - With
Handles "D"
Depth - Without
Handles "E"
Depth - Cabinet
Only "F"
Width - Cabinet
"G"
WRT108FFD
WRT138FFD
WRT148FZD
WRT318FZD
WRT318FMD
18.2 cu ft Yes 65
7
/
8
" (1673 mm) 65
3
/
8
" (1660 mm) 59
3
/
4
" (1518 mm) 33
1
/
2
" (850 mm) 31
3
/
8
" (797 mm) 28
7
/
8
" (733 mm) 29
3
/
4
" (756 mm)
WRT519SZD
WRT549SZD
19.2 cu ft Yes 65
7
/
8
" (1673 mm) 65
3
/
8
" (1660 mm) 59
7
/
8
" (1520 mm) 34
1
/
2
" (876 mm) 32
7
/
8
" (835 mm) 28
7
/
8
" (733 mm) 29
3
/
4
" (756 mm)
ELECTRICAL REQUIREMENTS
Electrical: A 115 V, 60 Hz, AC only, 15 A or 20 A fused, grounded electrical supply
is required. It is recommended that a separate circuit serving only your refrigerator
be provided. Use an outlet that cannot be turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning, or removing a light
bulb, turn the control (Thermostat, Refrigerator or Freezer Control depending on
the model) to OFF and then disconnect the refrigerator from the electrical source.
When you are nished, reconnect the refrigerator to the electrical source and reset
the control (Thermostat, Refrigerator or Freezer Control depending on the model)
to the desired setting. See “Using the Controls.”
Water: A cold water supply with water pressure between 30 psi and 120 psi
(207 kPa and 827 kPa) is required to operate ice maker and water dispenser. If
you have questions about your water pressure, call a licensed, qualied plumber.
IMPORTANT: The pressure of the water coming out of a reverse osmosis system
going to the water inlet valve of the refrigerator needs to be between 30 psi and
120 psi (207 kPa and 827 kPa).
Reverse Osmosis Water Supply: If a reverse osmosis water ltration system is
connected to your cold water supply, the water pressure to the reverse osmosis
system needs to be a minimum of 40 psi to 60 psi (276 kPa to 414 kPa).
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Top Mount Refrigerator
4
1
A
B
G
E
D
F
90˚
C
Top of
Cabinet
Including
Handle
Cabinet
Not Including
Handle
Overall
Height
W11558135A

Summary of content (2 pages)