Installation Instructions

16
Refer to the side diagrams for the following steps.
1. Position the ice maker inside the freezer compartment and
connect its wiring connector to the wiring harness connector
so they lock together (the locking arm will snap over the
raised tab). The connectors will t together only one way.
2. For Top/Bottom Freezers Only: Hang the ice maker over the
two hex-head screws you installed earlier. Make sure that the
bottom mounting bracket hole is aligned with the mounting
hole in the freezer liner, then tighten the two top hex head
screws. Be careful not to overtighten the screws.
3. For Side-By-Side Models Only: Position the ice maker so
that its top and bottom mounting tabs are at against the
side of the freezer liner. Center the top tabs under the two
mounting clips, and push the ice maker straight up so that
the mounting clips snap over the tabs and lock into place
(you should hear them “click” as they lock).
4. Mount the bottom bracket of the ice maker to the freezer
liner mounting hole with a 3⁄4" hex-head sheet-metal screw.
Screws
Tabs
Wiring
harness
connectors
1/2" hex-head
sheet-metal
screw
Bottom
mounting
bracket
Mounting the ice maker
(top and bottom freezers)
Wiring
harness
connectors
Insert fill
tube into
cup
Slide tabs
under clips
Ice maker
1
⁄2" hex-head
sheet-metal
screw
Bottom
mounting
bracket
Mounting the ice maker (side-
by-side models)