Owner's Manual

22
4. Lift the refrigerator door from the bottom hinge pin. The top
hinge will come away with the door.
NOTE: It may not be necessary to remove the bottom hinges
and brake feet assemblies to move the refrigerator through a
doorway.
� Only if necessary, depending on your model, use a driver
with a #2 square bit tip or a TORX T25 screwdriver to
remove the bottom hinges and a 3/8" nut driver or a TORX
T25 screwdriver to remove the brake feet screws.
Reset Bottom Refrigerator Door
Hinge
For your convenience, the refrigerator doors have bottom hinges
with door closers. These closers allow the doors to swing fully
closed with just a gentle push.
IMPORTANT: So that the closers feature will operate properly, the
doors must be removed only when open to a 90° angle to the front
of the cabinet. If one or both doors were not at a 90° angle when
removed, the bottom door hinge must be reset.
RESET THE DOOR HINGE
1. Lift the door from the bottom hinge pin and place it on a flat
surface.
2. Using a driver with a #2 square bit, remove the bottom hinge
with the bushing from the cabinet.
A. Bushing B. Hinge base
3. Insert the bottom hinge and bushing into the corresponding
slot in the bottom of the door.
NOTE: Make sure that the base of the hinge is parallel to the
bottom of the door.
A. Hinge base parallel to the bottom edge of the door
4. Turn the hinge until the hinge base is at a 90° angle to the
bottom edge of the door.
A. Hinge base turned to a 90° angle with the bottom edge of
the door
5. Remove the hinge from the door. Reattach the bottom hinge to
the refrigerator cabinet.
6. The hinge is now reset and prepared for the door to be
replaced.
Replace Refrigerator Doors and
Hinges
Replace Right-Hand Refrigerator Door
1. Set the right-hand door onto the bottom hinge pin.
2. Insert the top hinge pin into the open hole in the top of the
refrigerator door.
3. Fasten the hinge to the cabinet. Do not tighten the screws
completely.
Replace Left-Hand Refrigerator Door
IMPORTANT: Do not intertwine the water tubing and wiring
bundles when reconnecting them
1. Set the left-hand door onto the bottom hinge pin.
2. Fasten the hinge to the cabinet. Do not tighten the screws
completely.
3. If applicable, reconnect the water dispenser tubing.
Style 1 - Insert the tubing into the fitting until it stops and the
outer ring is touching the face of fitting.
Style 2 - Insert the tubing firmly into the fitting until it stops.
Close the clasp around the tubing. The clasp snaps into place
between the fitting and the collar.
4. Reconnect the electrical wiring.
� Push together the two sections of the wiring plug.