Instruction for Use

ManualsBrandsWhirlpool ManualsDomestic AppliancesWSLCSE 65 AS GR/1

400010910557

INSTALLATION AND USE

For installation: The minimum distance between the support surface of the

recipients on the cooking device and the lowest part of the hood must not be

less than 50 cm in the case of electric cookers and 65 cm for gas or combination

cookers. If the installation instructions for the gas cooker specify a greater

distance, this must be taken into account.

WARNING: Very heavy product; hood handling and installation must be

carried out by at least two persons.

Note on installation and use: Read this manual before installing or using

the hood. The Manufacturer declines all liability for any faults, damage or res

caused by the appliance as a result of failure to observe the instructions and

recommendations given in this manual.

This hood must be installed by a qualied technician. The installer must observe

the installation distances indicated on the rating plate of the product/range.

Summary of content (8 pages)

PAGE 1
GB INSTALLATION AND USE For installation: The minimum distance between the support surface of the recipients on the cooking device and the lowest part of the hood must not be less than 50 cm in the case of electric cookers and 65 cm for gas or combination cookers. If the installation instructions for the gas cooker specify a greater distance, this must be taken into account. WARNING: Very heavy product; hood handling and installation must be carried out by at least two persons.
PAGE 2
? 400010910557
PAGE 3
* only present on some models 400010910557
PAGE 4
Grease filter 400010910557 Carbon filter
PAGE 5
SAFEGUARDING THE ENVIRONMENT 4. 1. Packing Packing materials are 100% recyclable and are marked with the recycling symbol .Comply with the local regulations for disposal. The packing materials (plastic bags, polystyrene, etc.) are a potential source of danger and must be kept out of the reach of children. 5. 6. 2. Product This appliance is marked in compliance with European Directive 2012/19/EU, Waste Electrical and Electronic Equipment (WEEE).
PAGE 6
18. 19. 20. 21. 22. 23. 24. 25. 26. treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. Regular cleaning and maintenance is essential for correct hood operation and good performance. Frequently clean all encrustations from dirty surfaces to prevent the accumulation of grease. Regularly clean or replace filters. Do not “flambé” food under the hood. Naked flames could cause a fire.
PAGE 7
AFTER-SALES SERVICE Electrical connection The mains voltage must match that given on the rating plate located inside the hood. If provided with a plug, connect the hood to a socket complying with the current regulations and located in an accessible area.
PAGE 8
Extractor hood installation (A): fumes are extracted and expelled to the outside through an exhaust duct fixed to the flange C (bayonet coupling). Always shut off the unused exhaust outlet with the plug D1 provided (if provided- bayonet coupling). Important: some models are supplied with the upper hole B1 closed with a plug D1. Remove the plug to enable use. Important! Not all models have rear drain hole B2. Please note: if necessary, remove plastic piece D2 or D3 with the aid of pliers or a box cutter.