Door Reversal Instructions

3
2. Remove screw covers
Remove the screw covers and place them on the other side as
shown in the illustrations.
3. Reinstall grill cover
Reinstall the grill cover.
Reversing the Hinges and End Caps
1. Install hinge screws
Install the hinge screws (previously set aside in step 10) halfway on
the desired side of the cabinet.
2. Flip top hinge
Take the original top hinge, flip it, and place it in the bottom hinge
position on the opposite side. Slide onto the cabinet hinge screws.
The hinge tabs on the hinges should always face towards each
other.
A. Hinge tab
3. Flip bottom hinge
Take the original bottom hinge, flip it, and place it in the top hinge
position on the opposite side. Slide onto the cabinet hinge screws.
4. Tighten hinge screws
Fully tighten the top and bottom hinge screws.
Final Door Placement
NOTE: Before placing the door back on the ice maker, check all
installed parts to ensure there are no exposed screws, all screw
cover caps are on, and the door is facing the correct way with the
stainless steel side facing out.
1. Slide door onto hinges
Slide the door onto the hinges. Using Torx T25 screwdriver, install
the screws (removed in step 8) onto the door.
2. Reinstall screw covers
Reinstall the plastic screw covers to original locations on the
hinges.