Owner's Manual
10
Complete Installation
1. For non-vented (recirculating) installations only, install
charcoal lters over the grease lters, using the clips
provided in the kit. See the “Range Hood Care” section.
2. Install metal lters. See the “Range Hood Care” section.
3. Check the operation of the range hood blower and light.
Seethe “Range Hood Use” section.
NOTE: To get the most efcient use from your new range
hood,read the “Range Hood Use” section.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking
vapors,and odors from the cooktop area. For best results,
startthe hood before cooking and allow it to operate several
minutes after the cooking is complete to clear all smoke and
odors from the kitchen. The hood controls are located on the
front side of the canopy.
Range Hood Controls
A. Light button
B. Blower ON/OFF and minimum speed button
C. Blower speed medium button
D. Blower speed maximum button
A B C D
Operating the light
The button controls both lights. Press once forONand again
for OFF.
Operating the blower
The ON/OFF button turn the blower on and set the blower
minimumspeed and sound level for quiet operation. The speed
can be changed anytime during fan operation by pressing the
desired Blower Speed button.
Press the blower ON/OFF button a second time to turn the
blower off.
RANGE HOOD CARE
Cleaning
IMPORTANT: Clean the hood and grease lters frequently
according to the following instructions. Replace grease
ltersbefore operating hood.
Exterior Surfaces
To avoid damage to the exterior surface, do not use steel wool
or soap-lled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
■ Liquid detergent soap and water, or all-purpose cleanser
■ Wipe with damp soft cloth or nonabrasive sponge,
andthenrinsewith clean water and wipe dry.
Metal Grease Filter
1. Remove the lter by pulling the spring release handle
andthen pulling down the lter.
2. Wash metal lter as needed in dishwasher or hot
detergentsolution.
3. Reinstall the lter by making sure the spring release handles
are toward the front. Insert aluminum lter into upper track.
4. Push in spring release handle.
5. Push up on metal lter and release handle to latch into place.
6. Repeat steps 1-5 for the other lter.
Non-Vented (recirculating) Installation Filters
The charcoal lter is not washable. It should last up to 6 months
with normal use. Replace with Charcoal Filter Kit. See the
“Assistance or Service” section for information on ordering.
To replace charcoal lter:
1. Remove metal grease lter from range hood. See “Metal
Grease Filter” in this section.
2. Bend spring clips away from metal grease lter.
3. Place charcoal lter into top side of metal lter.
4. Bend spring clips back into place to secure the
charcoallterto the metal lter.
5. Replace metal grease lter. See “Metal Grease Filter”
inthissection.
Replacing a LED Lamp
The LED lights are replaceable by a service technician only.
Seethe “Warranty” section for service contact information.
A
A. Spring release handle