Owner's Manual
Table Of Contents
8
Install Range Hood
1. Remove screws from wooden shipping supports. Properly
dispose of shipping materials.
2. Using 2 or more people, hang range hood on 2 mounting
screws through the mounting slots on back of hood.
3. Remove the grease lter. See “Range Hood Care” section.
4. Level the range hood and tighten upper mounting screws.
5. Install (2) 5 x 45 mm #2 Phillips lower mounting screws and
tighten. Use the optional wall anchors if needed.
Connect Vent System
1. Install vent transition (A) on top of hood (if removed for
shipping) with (2) 3.5 x 9.5 mm T10 sheet metal screws. Use
T10 Torx
®
drive (or T10 adapter provided) to tighten.
For vented installations only:
1. Fit vent system over transition piece.
2. Seal connection with clamps.
3. Check that back draft dampers work properly.
For non-vented (recirculating) installation only:
1. Assemble the air deector with the duct cover bracket using
(4) 4.2 x 8 mm T20
®
screws. Use a T20
®
Torx
®
drive (or T20
®
adapter provided) to tighten.
2. Measure from the bottom of the air deector to the bottom of
the hood outlet.
3. Cut the duct to the measured size “X.”.
4. Remove the air deector.
5. Slide the duct onto the bottom of the air deector.
6. Place the assembled air deector and duct over the exhaust
outlet from the hood.
7. Reassemble the air deector to the duct cover bracket with
the 4 assembly screws.
8. Seal connections with vent clamps.
A
B
C
A
B
C
A
B
C
D
X
E
A. Mounting screws
B. Mounting slots
C. Lower mounting screws
A. Air deector
B. Vent clamp
C. X = length to cut vent duct
D. Vent duct
E. Exhaust outlet
A
B
A. Vent transition
B. 3.5 x 9.5 mm screw location
A. Assembly screws
B. Air deector
C. Duct cover bracket