Owner's Manual

10
RANGE HOOD USE
The range hood is designed to remove smoke, cooking
vapors,and odors from the cooktop area. For best results,
startthe hood before cooking and allow it to operate several
minutes after the cooking is complete to clear all smoke and
odors from the kitchen. The hood controls are located on the
front side of the canopy.
A. Grease lter
B. Grease lter handle
C. Blower and light controls
D. LED lights
Range Hood Controls
Buttons
A. Blower ON/OFF and decrease speed button
B. Blower ON and increase speed button
H. Delay off
I. Light button
Indicators
C. Blower speed indicator
D. Charcoal lter saturation
E. Grease lter saturation
F. Delay off
G. Light
A B C D E F G IH
Operating the light
The button controls both lights. Press once forONand again
for OFF. When button is pressed and lights are on the indicator G
will display.
Operating the blower
The blower can be turned on with both decrease and increase
buttons. To turn on and off the hood and decrease speed use
button A. To turn on the hood and increase speed up to 4
different speeds (low, medium, high and boost) use button B.
When Boost speed is on hood will be activated at maximum
speed for 5 minutes. After 5 minutes, the hood will slow to
medium speed.
Timer
The range hood can be set to automatically turn off after
5 minutes.
With the desired fan speed activated, press the Delay off button.
The fan will run on the chosen speed for 5 minutes, after 5
minutes, the fan will turn off automatically.
Pressing the Delay off button will cancel the 5-minute timer.
LCD screen
The LCD screen displays:
C. Extraction speed level indicator: the icon increases the
amount of lines around the blower according to the selected
speed.
D. Grease lter saturation indicator.
E. Charcoal lter saturation indicator (only in Recirculation
mode).
F. Automatic power-off timer indicator.
G. Lighting indicator.
Resetting the Filter Saturation Indicator
Following lter maintenance, hold H button down until the
indicator goes off.
Activating the Active Charcoal Filter Saturation
Indicator
The charcoal lter saturation indicator should only be activated
in Recirculation mode.
To activate it, make sure that the hood is switched off and
then press buttons A and H at the same time until the indicator
changes from a ashing light to a xed light. Repeat the
procedure to deactivate the function.
Automatic Operation at High Temperature
The hood is equipped with a temperature sensor. In the event of
a sudden temperature surge, the hood activates extraction until
the temperature has dropped signicantly.