Owner's Manual
11
RANGE HOOD CARE
Cleaning
IMPORTANT: Clean the hood and grease lters frequently
according to the following instructions. Replace grease
ltersbefore operating hood.
Exterior Surfaces
To avoid damage to the exterior surface, do not use steel wool
or soap-lled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
■ Liquid detergent soap and water, or all-purpose cleanser
■ Wipe with damp soft cloth or nonabrasive sponge,
andthenrinsewith clean water and wipe dry.
Metal Grease Filter
1. Remove the lter by pulling the spring released handle
andthen pulling down the lter.
2. Wash metal lter as needed in dishwasher or hot
detergentsolution.
3. Reinstall the lter by making sure the spring release handles
are toward the front. Insert aluminum lter into upper track.
4. Push in spring release handle.
5. Push up on metal lter and release handle to latch into place.
6. Repeat steps 1-5 for the other lter.
Non-Vented (recirculating) Installation Filters
NOTE: The maximum BTUs if you use carbon lter is 60,000.
If you use the hood with the carbon lters on and it does not
decrease the BTUs the engine can fail or generate an unsafe act.
1. Cover the grille that covers the blower motor with the
charcoal lter so that the slots on the lter correspond to the
pins on the sides of the motor grille.
2. Turn the charcoal lter clockwise to lock it.
3. Repeat steps 1-2 on the other lter.
The charcoal lter is not washable. It should last up to
6monthswith normal use. When used in recirculation mode, To
Reduce Risk of Fire and Shoc replace with Charcoal Filter Kit
only. See the “Assistance or Service” section to order.
C
B
A
A. Charcoal Filter
B. Pins
C. Blower Motor
Replacing a LED Lamp
The LED lights are replaceable by a service technician only.
Seethe “Warranty” section for service contact information.
A
A. Spring release handle