Installation Sheet

RANGE HOOD CARE

Cleaning

IMPORTANT: Clean the hood and grease lters frequently

according to the following instructions. Replace grease

ltersbefore operating hood.

Exterior Surfaces

To avoid damage to the exterior surface, do not use steel wool

or soap-lled scouring pads.

Always wipe dry to avoid water marks.

Cleaning Method:

■ Liquid detergent soap and water, or all-purpose cleanser

■ Wipe with damp soft cloth or nonabrasive sponge,

andthenrinsewith clean water and wipe dry.

Metal Grease Filter

1. Remove the lter by pulling the spring released handle

andthen pulling down the lter.

2. Wash metal lter as needed in dishwasher or hot

detergentsolution.

3. Reinstall the lter by making sure the spring release handles

are toward the front. Insert aluminum lter into upper track.

4. Push in spring release handle.

5. Push up on metal lter and release handle to latch into place.

6. Repeat steps 1-5 for the other lter.

Non-Vented (recirculating) Installation Filters

NOTE: The maximum BTUs if you use carbon lter is 60,000.

If you use the hood with the carbon lters on and it does not

decrease the BTUs the engine can fail or generate an unsafe act.

1. Cover the grille that covers the blower motor with the

charcoal lter so that the slots on the lter correspond to the

pins on the sides of the motor grille.

2. Turn the charcoal lter clockwise to lock it.

3. Repeat steps 1-2 on the other lter.

The charcoal lter is not washable. It should last up to

6monthswith normal use. When used in recirculation mode, To

Reduce Risk of Fire and Shoc replace with Charcoal Filter Kit

only. See the “Assistance or Service” section to order.

A. Charcoal Filter

B. Pins

C. Blower Motor

Replacing a LED Lamp

The LED lights are replaceable by a service technician only.

Seethe “Warranty” section for service contact information.

A. Spring release handle